User Manual

33
CHANGING PARAMETERS AFTER RECALLING PRESETS
Normally the PRESET LED lights solid after loading a preset. If you turn a
knob, press a button in the top row, or tap in a new delay time, the PRESET
LED blinks to indicate that a preset is loaded but has been altered.
RELOADING ALTERED PRESETS
In the situation where a preset has been altered and therefore the PRESET
LED is blinking, press and release the DELAY TYPE knob to recall the preset
for the current Delay Type or the Looper mode.
SAVING ALTERED PRESETS
If you would like to save an altered preset to the current Delay Type, press
and hold the DELAY TYPE knob for about 2.5 seconds. Release once the
PRESET LED stops blinking and is lit solid.
Note: altered Expression
Settings are automatically saved to presets. See below.
UNLOADING PRESETS
To unload a preset and return to What You See Is What You Get mode
(WYSIWYG):
1. Ensure the PRESET LED is lit solid
2. Press and release the DELAY TYPE knob.
3. The PRESET LED shuts off and you are in WYSIWYG mode.
SAVING EXPRESSION PEDAL SETTINGS TO PRESETS
If the EXP MODE button is on when a preset is saved, the current
Expression Setting will be saved to that Delay Type’s or Looper’s preset.
The EXP MODE button will be saved in the on state.
If a new custom Expression Setting is created while a preset has been
loaded (the PRESET LED is lit), the new setting will be automatically saved
to the preset. The PRESET LED will blink at the end of the Expression
Setting creation procedure to indicate that the new setting has been saved
to the preset. Note: if an expression pedal setting is created and saved
while the preset is loaded, any other unsaved control alterations will be
lost. Make sure to save any desired knob alterations to the preset before
updating the preset's Expression Setting.