User Manual

6
USING AN EXPRESSION PEDAL
1. Connect your expression pedal to the EXP jack.
2. While the EXP MODE button is off, the expression pedal acts like a
volume control for your dry signal before it enters the Grand Canyon.
3. While the EXP MODE button is enabled, the expression pedal sweeps
all parameters that are assigned to it for the currently selected Delay
Type or Looper mode.
4. You may assign any knobs you like to be swept by the expression
pedal. Additionally each knob may have a custom range and direction.
See page 29 of the manual to learn how to create an Expression
Setting for each Delay Type and for the looper.
SAVING A PRESET
1. Once you have created a sound that you would like to save, press and
hold the DELAY TYPE knob.
2. After about half a second, the PRESET LED will begin blinking rapidly.
Continue holding down the DELAY TYPE knob.
3. After two seconds of holding down the DELAY TYPE knob, the PRESET
LED will stop blinking and light up solid. You can now release the
DELAY TYPE knob.
4. Your preset is saved in the currently selected Delay Type. You may
save one preset for each of the 12 Delay Types and one preset for
Looper mode.
RECALLING A PRESET
1. Turn the DELAY TYPE knob to the Delay Type you want to recall.
2. Press and release the DELAY TYPE knob. The preset sound loads and
the PRESET LED lights solid.
3. If you turn a knob or change a button setting, the PRESET LED will
blink rapidly to indicate a preset is loaded but the setting has been
altered.