User Manual

ManualsBrandsElectro Harmonix ManualsDelays - EcoDeluxe Memory Man - Tap Tempo 1100 - 1100MS DIGITAL DELAY EFFECT WITH TAP TEMPO

DELUXE MEMORY MAN w/

TAP TEMPO

TAP TEMPO ANALOG DELAY with FX LOOP,

MODULATION and EXPRESSION PEDAL

CONTROL

Congratulations on your purchase of the Electro-Harmonix Deluxe

Memory Man w/ Tap Tempo (DMMTT). The DMMTT is designed with

high quality, new old-stock bucket brigade ICs for an analog delay sound

equal to the original Deluxe Memory Man. In addition to Tap Tempo

control of the delay time, the DMMTT also includes delay time

modulation, an effects loop in the feedback path of the delay block, an

input gain control, tap tempo divide and optional expression pedal

control over five parameters: Delay Time, Feedback, Modulation Depth,

Rate and Blend. The DMMTT is true bypass.

-CONTROLS and INDICATORS -

KNOBS

DELAY Knob – Sets the delay time from 52 mS to 1100 mS. As you turn the

DELAY knob clockwise, the delay time will increase. If you tap in the delay time,

the DELAY knob’s setting will be ignored until you move it again. If you turn the

DELAY knob after tapping in a delay time, the DELAY knob’s setting will

supersede the last tap tempo that was entered. Turning the DELAY knob, while

listening to your echoes, will bend the pitch of your notes. The DELAY knob can

also be used to set the maximum delay time for expression pedal control. N.B.:

the TAP DIVIDE button functions have no effect on the DELAY knob; pressing

WARNING: Your Deluxe Memory Man w/ Tap Tempo comes equipped

with an Electro-Harmonix 9.6DC-200BI power supply (same as used by

Boss

& Ibanez

: 9.6 Volts DC 200mA). The Deluxe Memory Man w/ Tap

Tempo requires 200mA at 9VDC with a center negative plug. The DMMTT

does not take batteries. Using the wrong adapter may damage your unit

and void the warranty.

Summary of content (8 pages)

PAGE 1
DELUXE MEMORY MAN w/ TAP TEMPO TAP TEMPO ANALOG DELAY with FX LOOP, MODULATION and EXPRESSION PEDAL CONTROL Congratulations on your purchase of the Electro-Harmonix Deluxe Memory Man w/ Tap Tempo (DMMTT). The DMMTT is designed with high quality, new old-stock bucket brigade ICs for an analog delay sound equal to the original Deluxe Memory Man.
PAGE 2
this button when the DELAY knob controls the delay time will not change the delay time. FEEDBACK Knob – Controls the amount of signal that is circulated from the output of the delay block to its input. Turning the FEEDBACK knob clockwise increases the number of echoes. Setting the FEEDBACK control to its maximum clockwise position will cause the DMMTT to run-away, or self-oscillate. Alternatively setting the FEEDBACK knob to its minimum position will yield just one echo or repeat for each of your notes.
PAGE 3
expression pedal will control that parameter. For example, if the RATE LED is lit, the expression pedal controls the modulation rate, from slowest (expression pedal = toe up), to the RATE knob’s current setting (expression pedal = toe down). When no EXP. MODE LEDs are illuminated the expression pedal is disabled while it remains plugged into the DMMTT. The setting for the EXP. MODE is saved and recalled when power cycling. TAP Footswitch – The TAP FSW is used to tap in the delay time.
PAGE 4
TAP DIVIDE Button and LEDs – This button cycles through the six possible settings for TAP DIVIDE. Each setting, except when all LEDS are off, will divide the tap tempo to create shorter delay times in sync with your original tempo. It works like so: The DMMTT always assumes that the musician taps in a quarter note. That quarter note can then be divided down to five other types of notes: dotted eighth note, quarter note triplet, eighth note, eighth note triplet and sixteenth note.
PAGE 5
I/O & POWER JACKS INPUT Jack – Connect the output of your instrument or other effects pedal to the ¼” INPUT jack. The impedance presented at the INPUT jack is 100 k. OUTPUT Jack – Connect the output of the DMMTT to the input of an amplifier or another effects pedal. The output impedance is 200 . SEND Jack – Connect this jack to the input of another effects pedal or chain of effects pedals to insert an effects loop before the DMMTT’s delay block.
PAGE 6
Roland EV-5 or Boss FV-500L. You may also connect a control voltage on TS plug to this jack. The Control Voltage range must be 0 V to 5 V. EXPRESSION PEDAL CONTROL – The Deluxe Memory Man w/ Tap Tempo allows external control over five of its parameters: BLEND, modulation RATE, modulation DEPTH, FEEDBACK and DELAY time. Please see the EXP. PEDAL Jack section above for suggestions on the type of expression pedals to use. The pedal will need to have a TRS plug.
PAGE 7
These external switch connections work in parallel with their associated buttons on the DMMTT. If either of the buttons have been enabled for external use, a TRS plug must be inserted into the TAP SW jack. In this circumstance, if a TS plug is inserted into the TAP SW jack it will be equivalent to holding down whichever button has been enabled for external use, without the ability to release the button.
PAGE 8
- WARRANTY INFORMATION Please complete and return the enclosed warranty card within 10 days of purchase or register online at http://www.ehx.com/product-registration . We will repair the unit at no charge within one year of date of purchase.