User Manual

CONNECTIONS & POWER
INPUT Jack — This 1/4” jack is the input to the Ripped Speaker. Plug your
instrument into here. The input impedance is 1MΩ.
AMP Jack — This 1/4” jack is the Ripped Speaker’s output. Connect this to the
input of your next effect or amplifier. Output impedance is 100Ω.
PWR Jack — The Ripped Speaker can be powered by a 9V battery or you can use
an optional 9VDC AC Adapter capable of delivering at least 25mA to the 9V power
jack, such as the EHX9.6DC-200. The AC Adapter must have a center negative
plug. The battery may be left in or taken out when using an AC Adapter. The
Ripped Speaker’s current draw is 10mA at 9VDC.
Please Note: Using the wrong adapter or a plug with the wrong polarity
may damage your Ripped Speaker and void the warranty.
CHANGING THE BATTERY
To change the 9V battery, you must remove the 4 screws on the bottom of the
Ripped Speaker. Once the screws are removed, you can take off the bottom plate
and change the battery. Please do not touch the circuit board while the bottom
plate is off, or you risk damaging a component.