User Manual

3
NEO CLONE SECTION
RATE Knob – Controls the Neo Clone’s speed of modulation. As you turn the
RATE knob clockwise, the modulation speed of the chorus gets faster. The speed
of modulation varies from 0.4 Hz to 9 Hz.
DEPTH Button – Changes the intensity, or depth, of the chorus effect choosing
between high and low depth. In the up position, the Neo Clone chorus is set to
low depth, giving a subtle chorus effect. The Neo Clone LED lights up red in the
lower depth position. When the button is pushed in, the chorus’ depth is set to
high for a more intense chorus effect. The Neo Clone LED lights up green when
the button is pushed in.
MEMORY TOY SECTION
DELAY Knob – Controls the delay time of the Memory Toy section of the Tone
Tattoo. As you turn the DELAY knob clockwise, the delay time increases. The
range of delay time is 30mS to 550mS.
FEEDBACK Knob – Controls the number of echo repeats each note produces.
As you turn FEEDBACK clockwise, the number of repeats increases. When you
turn FEEDBACK all the way down, you will only hear one echo for each note you
play. If you turn FEEDBACK up to its maximum clockwise position, the Memory
Toy’s echoes will build on top of each other for a “run-away” effect after you play
a note. A fairly high feedback setting with short delay settings produces a reverb
type of effect.
BLEND Knob – Allows you to vary the mix of the dry signal coming into the
Memory Toy section with the delayed signal produced within the Memory Toy
effect. BLEND varies from 100% dry, when set to full counter-clockwise, to
100% wet at full clockwise.
GAIN Knob – Controls the input gain into the Memory Toy. As you turn the
GAIN knob clockwise the gain increases, making for a louder overall effect. The
GAIN knob increases the volume of both the dry and delayed signal. Use the
GAIN knob in conjunction with the BLEND knob to set the Memory Toy to your
preferred volume. Please Note: the delay signal will saturate before the dry
signal. The range of the GAIN knob is 0dB to +23dB.
FOOTSWITCHES & LEDs
Each effect section of the Tone Tattoo has its own independent footswitch to
toggle the associated effect in and out of bypass. Bypass through the Tone
Tattoo is buffered bypass.
METAL MUFF Footswitch and STATUS LED - The footswitch located nearest
to the IN jack toggles the Metal Muff effect on or off. When the LED in the Metal
Muff section is lit (either red or green), the Metal Muff effect is active. When the