Specifications

Panel Mounting
1. Remove the contact block and the M30 jam nut from the actuator and verify that the rubber gasket is in place.
2. Align the anti-rotation key on the bezel with the keyway (notch) in the panel.
3. Insert the actuator into the hole from the front of the panel, and tighten the M30 jam nut using wrench SSA-EB1-LRW or SSA-EB1-
LRTW to a maximum torque of 2.5 N•m (1.8 ft-lbs).
NOTE:
• The allowable panel thickness is 1 mm to 5 mm for SSA-EB1P… and 1 mm to 6 mm for SSA-EB1M….
• Banner recommends that the anti-rotation key/keyway is placed at the top of the hole (0° versus 90°
or 180°) so the word “TOP” on the contact block and actuator is on the top so that the terminal label is
easier to read.
• If using ESLP1-30/60-.. Plastic Emergency Stop legend, remove the anti-rotation projection on the leg-
end using pliers, and then install the legend onto the actuator before inserting it into the hole.
Install the Contact Block
1. Arm (reset) the actuator (button). Do not attempt to install the contact block while the actuator is latched (pushed), or the switch may
be damaged.
2. Align the small ▼ mark on the edge of the actuator with the small ▲ mark on the yellow bayonet ring. The contact block (TOP
LOCK) should be turned approximately 45° counterclockwise from the anti-rotation key/keyway on the bezel.
3. Hold the black contact block (not the yellow bayonet ring), and slide the contact block onto the actuator. Push until the actuator is fully
inserted into the contact block (the bayonet ring will compress and motion will stop).
NOTE: If not installed on a panel, press on the actuator’s bezel (not the button).
4. Turn the contact block clockwise until the yellow bayonet ring pops into position and clicks.
When properly seated, the contact block cannot be turned or pulled.
Push
Mark
Mark
TOP Lock
TOP
Turn
Clockwise
Hookups
Non-Illuminated E-Stop Con-
tact
Hookup Illuminated E-Stop Con-
tact
Hookup
SSA-EB1P-02
SSA-EB1MP-02
2 N.C.
12
11
21
22
SSA-EB1PL1-02
SSA-EB1ML1P-02
2 N.C.
12
11
21
22
X2X1
LED24V
SSA-EB Series Emergency Stop Push Buttons
4 www.bannerengineering.com - tel: [phone] P/N 168349_web
Rev. B