Industrial Electro Boilers Large Specifications Sheet

Electro Industries’
Industrial Electric Water Boilers
Electro Industries’ Industrial Boiler is a very compact and an effective solution to retrofi tting old, ineffi cient fossil fuel
boilers, or for use in new installations.
Safety is one major benefi t of these boilers. Several state electrical jurisdictions are requiring the (optional) Bender
Insulation Monitor device (ground fault) for increased operating safety, personal protection and reliability of the boiler.
Secondly, there are individual circuit breakers for each heating element, further increasing the safety and reliability of our
boilers.
Each boiler also includes built-in digital supply return and outdoor temperature sensors, enabling you to internally set and
maintain the correct system design temperature, simplifying the installation process.
Features & Benefits
Pressure vessel built in accordance with the
requirements of the ASME Boiler and Pressure Vessel
Code (National Board and CRN registered)
Compact, can easily fi t through service doors
High effi ciency electric boiler with no combustion waste
No minimum return water temperature required
Individual circuit breakers for each heating element
All boilers come fully assembled; control box is within
front door
Built-in digital temperature sensing; adjustable desired
temperature allows the user to set the boiler to operate
at a specifi c supply temperature (set point mode)
Outdoor reset (can be enabled or disabled)
Outdoor reset sensing and software (reset mode)
Operator alarm monitor and control functions including
manual resets are in the control box
All parts within the boiler are rated for 60° C
Optional remote display - water temperature, set point,
percent on, alarm status, estimated GPM. In addition,
design includes provisions for phone dialer, Web
controller, etc.
Optional Honeywell T775R temperature control
0-10VDC terminal enabling control of boiler via building automation system, etc.
Software and interface cable for setup, monitoring, and troubleshooting
Transformer Wiring Configurations
Standard boiler - add to building electrical service, 4-wire but no neutal current. All service wiring design, safety and ground fault
equipment, NEC special code application, etc. are the responsibility of the installer.
Standard boiler with option ground fault monitor - suitable for use with a 3-wire Delta service, dedicated utility transformer
(Delta or unbonded/neutral). All control and protection needed to meet NEC Article 250 is included.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Made in USA