Owner's Manual

Installing the eyebolts
To install the eyebolts, do the following:
1. Remove the three fly point covers from the suspension points.
2. Install M10 eyebolts and fender washers into the suspension points.
!
Warning!
Eyebolts must be fully seated and oriented in the plane of pull. Always use fender washers at
least 1.5 inch in diameter and 1/16 inch thick under the eyebolt to distribute the load on the
enclosure.
B
A
Figure 4.2: Eyebolt shown with washers (A) and without washers (B)
en 17
Electro-Voice Installation manual 2017.06 | 01 | F.01U.326.891