Owner's Manual
Table Of Contents
- Installation Manual
- Table of Contents
- 1 Safety
- 2 Welcome
- 3 System overview
- 4 Installation and Wiring
- 4.1 Step 1 — Cut the Hole
- 4.2 Step 2 — Install C-Ring and/or Tile Rails
- 4.3 Step 3 — Attach Wiring to the Terminal Connector
- 4.4 Step 4 — Secure the Cable to the Speaker
- 4.5 Step 5 — Mount the Speaker into the Ceiling
- 4.6 Step 6 — Connect an Auxiliary Support Line
- 4.7 Step 7 — Adjust Tap Selector
- 4.8 Step 8 — Attach the Grille
- 5 Troubleshooting
- 6 Technical data
- 7 Appendices
- Product Info
- Warranty
- Safety Notes
EVID Ceiling Speaker Systems Installation and Wiring | en 13
Electro-Voice Installation manual 2018.09 | 11 | F.01U.177.705
From amplifier or
previous speaker
To next speaker
Figure4.6: Parallel wiring
Daisy-Chaining
Connect the wire pair of the subsequent speaker to pins 1 and 4. When one input connector is
removed, subsequent speakers will also be disconnected.
From amplifier or
previous speaker
To next speaker
Figure4.7: Daisy-Chain wiring
INSTALLATION NOTE: SUBWOOFER POLARITY
When adding a subwoofer, be sure to observe the correct polarity. The C10.1 subwoofer has
been designed for optimum performance when used with the C4.2 or C4.2LP. In order to
maximize the low frequency output when used with the C6.2 , C8.2, C8.2LP or C8.2HC, the
polarity of the C10.1 subwoofer should be reversed.
C10.1 Subwoofer C4.2 Loudspeaker
+
-
C4.2LP Loudspeaker
Figure4.8: Subwoofer polarity with C4.2/C4.2LP
C10.1 Subwoofer
C8.2/C8.2HC/C8.2LP
Loudspeaker
+
-
+
-
C6.2 Loudspeaker
Figure4.9: Subwoofer polarity with C6.2 or C8.2/C8.2HC/C8.2LP