Owner's Manual
Table Of Contents
- Installation Manual
- Table of Contents
- 1 Safety
- 2 Welcome
- 3 System overview
- 4 Installation and Wiring
- 4.1 Step 1 — Cut the Hole
- 4.2 Step 2 — Install C-Ring and/or Tile Rails
- 4.3 Step 3 — Attach Wiring to the Terminal Connector
- 4.4 Step 4 — Secure the Cable to the Speaker
- 4.5 Step 5 — Mount the Speaker into the Ceiling
- 4.6 Step 6 — Connect an Auxiliary Support Line
- 4.7 Step 7 — Adjust Tap Selector
- 4.8 Step 8 — Attach the Grille
- 5 Troubleshooting
- 6 Technical data
- 7 Appendices
- Product Info
- Warranty
- Safety Notes
16 en | Installation and Wiring EVID Ceiling Speaker Systems
2018.09 | 11 | F.01U.177.705 Installation manual Electro-Voice
Figure4.13: Mount speaker into ceiling
!
<=12 in. lbs.
(1.35 Nm)
Figure4.14: Tighten mounting tabs
INSTALLATION NOTE: MOUNTING TABS
For each attachment screw, first turn one half-turn counterclockwise to release the mounting
tab from its guide.
4.6 Step 6 — Connect an Auxiliary Support Line
Note the support ring on the back of the speaker. The ring allows for connection to a
independent and secure anchor point. Construction codes often require the use of this
secondary support point.
!
Caution!
Ceiling mount speaker’s safety cable
The safety cable should be installed with 1-3 inches (25.4-76.2 mm) of slack.