Owner's Manual
Table Of Contents
- Installation Manual
- Table of Contents
- 1 Safety
- 2 Welcome
- 3 System overview
- 4 Installation and Wiring
- 4.1 Step 1 — Cut the Hole
- 4.2 Step 2 — Install C-Ring and/or Tile Rails
- 4.3 Step 3 — Attach Wiring to the Terminal Connector
- 4.4 Step 4 — Secure the Cable to the Speaker
- 4.5 Step 5 — Mount the Speaker into the Ceiling
- 4.6 Step 6 — Connect an Auxiliary Support Line
- 4.7 Step 7 — Adjust Tap Selector
- 4.8 Step 8 — Attach the Grille
- 5 Troubleshooting
- 6 Technical data
- 7 Appendices
- Product Info
- Warranty
- Safety Notes
EVID Ceiling Speaker Systems Appendices | en 27
Electro-Voice Installation manual 2018.09 | 11 | F.01U.177.705
Model 8' 12' 20' 24'
C8.2 11.5' 23' 45' 57'
C8.2LP 11.5' 23' 45' 57'
C8.2HC 6.5' 12' 24' 30'
C10.1 180° coverage
Tab.7.1: Coverage Diameter by Ceiling Height
7.2.3 Use of Subwoofers
The C10.1 subwoofer can add considerable low frequency performance to any EVID
installation. It is important to note that the C10.1 subwoofer depends on the ceiling and walls
to properly load itself and to reinforce its bass output. Correct positioning is important to get
maximum impact.
In smaller rooms when a single C10.1 is used, a center or near-center position is best. This
gives the most even coverage. For larger rooms where more than one C10.1 are employed, the
added effect of the room’s walls can be used. In such a space, position the subwoofers evenly
throughout the room and a few feet from the wall or corners. The added loading of the walls
will enhance the response in these larger areas.