Information

64 65
ELECTRONICS
ELECTRONICS
Tour Grade Amplifiers
Designed for the most demanding applications in both
touring and installed sound, EV's ultra-reliable Tour Grade
amplifiers offer a unique combination of output power,
sonic excellence and high efficiency, all in a compact,
lightweight format that's ideal for life on the road. Based
on grounded-bridge Class-H topology, Tour Grade amps
feature an integrated switch-mode power supply for
maximum power per pound, with plenty of headroom to
handle transient peaks and low loads. The optional RCM-
26 remote control module adds state-of-the-art IRIS-
Net-controlled DSP, including FIR-Drive loudspeaker
optimization, IIR filters, signal routing, level control,
dynamics and system supervision. The optional RCM-28
module provides additional DSP options as well as the
revolutionary OMNEO Media Networking Architecture for
the most demanding applications.
TG5 and TG7 rear view
UCC1
REMOTE CONTROL INTERFACE FOR IRISNET
• USB-CAN converter for IRIS-Net enabled devices
• Supports up to 100 CAN devices
• Parallel CAN connections on RJ-45 Ethercons
• USB-powered
• XLR jack for audio bus monitoring
• 19" rackmount panel included
• Status LED shows CAN activity and device status
RCM-28
IRISNET REMOTE CONTROL MODULE FOR TOUR GRADE AMPLIFIERS
• OMNEO Media Networking Architecture
• Advanced FIR-Drive loudspeaker optimization
• High precision load impedance supervision
• Two GPI and two GPO ports
• One-button system test for fast, complete
check of connected cables and components
• Pilot tone detection for cable supervision
• Dedicated Array EQ and Delay DSP
• Recallable DSP/configuration presets
TG5 TG7 RCM-26 RCM-28
Topology Class-H grounded bridge Class-H grounded bridge
Impedance 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω
Continuous Output/Channel (1 kHz, THD 1%) 2000 W 1450 W 850 W 3500 W 2500 W 1500 W
Continuous Output/Channel
(20–20,000 Hz, THD < 0.2%)
1200 W 600 W 2100 W 1050 W
Maximum Bridged Output: 4, 8 Ω 3800 W 2900 W 7000 W 5000 W
Amplifier Gain (Selectable) 39, 35 or 32 dB 41.5, 35 or 32 dB
Signal-to-Noise Ratio (A-weighted) 109 dB 111 d B 116 dB 120 dB
Total Harmonic Distortion 0.05% 0.05% <0.005% (THD+Noise) <0.002% (THD+Noise)
Intermodulation Distortion (SMPTE) 0.05% 0.05%
DIM 30 0.02% 0.02%
Slew Rate 30 V/µs 35 V/µs
Analog Inputs Ye s Ye s 2 audio inputs on internal slot connector, pre-/post-fader selectable
Input Impedance (Balanced) 20 kΩ 20 kΩ
Input Sensitivity (Selectable) 0, +6, +7 dBu 0, +6, +9 dBu
Digital Inputs Optional (RCM-26 / RCM-28) Optional (RCM-26 / RCM-28) AES3 (AES/EBU) format, XLR In/Thru connectors
A/D Conversion See RCM-26 / RCM-28 See RCM-26 / RCM-28 24 Bit linear, Sigma-Delta, 128x oversampling
D/A Conversion See RCM-26 / RCM-28 See RCM-26 / RCM-28 24 Bit linear, Sigma-Delta, 128x oversampling
Data Format See RCM-26 / RCM-28 See RCM-26 / RCM-28 24 Bit linear A/D and D/A conversion, 48 Bit processing
Internal Processing See RCM-26 / RCM-28 See RCM-26 / RCM-28 2 DSPs (150 MHz, 300 MIPS) Dual Core DSP, 500 MIPS
Sample Rate See RCM-26 / RCM-28 See RCM-26 / RCM-28 48 kHz 48 kHz
Sample Rate Conversion (SRC) See RCM-26 / RCM-28 See RCM-26 / RCM-28 32 kHz – 192 kHz internal sample rate converter
Network Control (IRIS-Net) Optional (RCM-26 / RCM-28) Optional (RCM-26 / RCM-28) Yes IRIS-Net control/OMNEO
Control Protocol See RCM-26 / RCM-28 See RCM-26 / RCM-28 CAN Bus OMNEO/OCA
CAN Bus Interface See RCM-26 / RCM-28 See RCM-26 / RCM-28 10–500 kbaud, 2x RJ-45 (IRIS-Net Control) Not required because of OCA support
GPIO Control Port See RCM-26 / RCM-28 See RCM-26 / RCM-28 1 x 6-pole Euroblock, 2 control inputs, 2 control outputs, (+5 V, 200 mA /GND)
FIR-Drive Optional (RCM-26 / RCM-28) Optional (RCM-26 / RCM-28) Ye s Ye s
Power Supply 100–240 V, 50-60 Hz 100–240 V, 50-60 Hz
Power Consumption 1/8 max. output @ 4 Ω 1000 W 1450 W
Dimensions (H x W x D)
3.47" x 19" x 20.16"
(88.1 x 482.6 x 512 mm)
3.47" x 19" x 20.16"
(88.1 x 482.6 x 512 mm)
3.33" x 3.17" x 9.06"
(84.7 x 80.4 x 230.3 mm)
3.33" x 3.17" x 9.06"
(84.7 x 80.4 x 230.3 mm)
Net Weight 31.4 lb (14.2 kg) 32 lb (14.5 kg) 0.53 lb (240 g) 0.53 lb (240 g)
TG5
TG7
2000 W PER CHANNEL POWER AMPLIFIER
3500 W PER CHANNEL POWER AMPLIFIER
• High-level touring performance
• Rugged, lightweight package
• 2000 W per channel (2 Ω)
• Grounded-bridge Class-H design
• Switch-mode power supply
• Microprocessor-controlled
• Front LCD panel for operation-
mode setup and monitoring
• Slot for optional RCM-26 or RCM-28 IRIS-
Net-compatible DSP and control module
• 11-level protection package
• Only 31.4 lb (14.2 kg)
• High-power performance for top-level tours
• Rugged, lightweight package
• 3500 W per channel (2 Ω)
• Grounded-bridge Class-H design
• Switch-mode power supply
• Microprocessor-controlled
• Front LCD panel for operation-
mode setup and monitoring
• Slot for optional RCM-26 or RCM-28 IRIS-
Net-compatible DSP and control module
• 11-level protection package
• Only 32 lb (14.5 kg)