User's Manual

19
2.3.1 | Bodypack Transmitter Setup & Operation
1. Insert Batteries
a. Open the battery compartment by pressing in on the latch and sliding the door down.
b. Insert two AA batteries with + and – as indicated.
c. Close the battery door by pushing up.
2. Turn the unit on by pressing and holding the on/off button for 3 seconds, and the LCD display
will light up. If channel has not been set, set channel according to 2.1.
3. Microphone/Guitar Operation.
a. For Lapel the gain switch should be in the LAV position.
b. For Headworn Microphones the gain switch should be in the INS position.
c. If lapel microphones are too sensitive and the audio meter on the receiver is reaching the
peak, put the gain switch in INS to lower the gain.
d. For guitar operation using the optional R300GTRCBL cable, the gain switch should
be in the LAV position for passive pickups, and in the INS position for active pickups.
Should the output of the passive pickups be too high in the LAV position, switch to the
INS position for reduced transmitter input gain.
4. Mute Function – press and hold on/off button for 2 seconds until MUTE appears in the LCD
display, On LED turns red, and sound mutes. Repeat to turn mute off.