R100 SERIES WIRELESS OWNERS MANUAL
R100 OWNERS MANUAL TABLE OF CONTENTS DESCRIPTION .......................................................................................................................................... 2 R100 SERIES COMPONETS ................................................................................................................... 3 QUICK SETUP AND USE ..................................................................................................................... 4-5 COMPATIBILITY ........................
R100 OWNERS MANUAL R100 SERIES OWNER’S MANUAL R100 System Features True-diversity system with Secure-Phasetm circuitry ensures maximum range and freedom from interference Well-designed companding and audio circuitry insure high signal-to-noise ratio and excellent sound quality Choice of handheld, bodypack, lavalier, headset and guitar systems Permanently attached antennas make setup quick and easy. Receivers can be rackmounted with optional kit.
R100 OWNERS MANUAL QUICK SETUP AND USE To get your system into operation quickly, use the following instructions. Review the rest of the manual for additional setup and operational details. 1. Place the receiver where there is a clear line of sight to the area where the transmitter will be used. Extend the receivers antennas to full length and separate them 90 degrees (see Figure 1). 2. Make sure the sound systems volume is low or off on the input you intend to use for the wireless. 3.
R100 OWNERS MANUAL Figure 3 BODYPACK TRANSMITTER SETUP 1. Insert battery. Open the hinged battery compartment by placing your thumb or finger on the indent on the battery door and pull down. When inserting the battery, pay attention to the polarity (+/-) and insert the terminals first into the battery compartment. Close the battery door by sliding the door shut. 2. Turn on the transmitter by sliding the power switch to its on position.
R100 OWNERS MANUAL COMPATIBILITY The receiver and transmitter must be tuned to the same VHF frequency to operate together. Because of the specialized equipment required to adjust these units properly, users cannot change frequencies. If two or more R100 and/or other VHF/UHF wireless systems are being used in the same location, proper frequency coordination is required to avoid interference.
R100 OWNERS MANUAL R100 SYSTEM SPECIFICATIONS SPECIFICATIONS Receiver Type Single-frequency, single-conversion superheterodyne FM Frequency Range (RF) 174.100 – 185.300 MHz Available Frequencies 174.100; 178.100; 178.500; 179.100 180.200; 183.700; 184.350; 185.350 MHz Diversity Full True Diversity RF Sensitivity < .8 uV for 12 dB SINAD FCC Data Approved under part 15 Audio Output, Frequency Response 20 – 15 kHz + 2 dB Audio Output Level 0.775V RMS @ 100 K ohm load Distortion Less than 0.
R100 OWNERS MANUAL FCC REGULATIONS The Electro-Voice Models BLV, BPV, BGV and HTV Transmitters are Type Accepted under United States Federal Communications Commission Part 74H. The Electro-Voice Models RCV and GRV Receivers are accepted under the Part 15 Notification Procedure of the Federal Communications Commission. Licensing of Electro-Voice equipment is the users responsibility and license ability depends on upon the users classification, and frequency selected.
R100 OWNERS MANUAL IN CASE OF DIFFICULTY Problem Possible Causes Solutions No audio Transmitter audio switch is off. Turn on transmitter audio switch. Disconnected or damaged receiver audio cable Connect, repair, or replace cable. Transmitter power switch is off. Turn transmitter power switch on, with level down on mixer/preamp/amplifier. Receiver is off. Turn on receiver. No (or dead) battery in transmitter.
R100 OWNERS MANUAL INSTALATION FOR RECEIVER RACK MOUNT KIT R-Series wireless receivers can be rack mounted with the optional RMR kit. The RMR allows two receivers to be mounted side-by-side in a single rack space. Attach Bracket to Receiver 1. Fold antennas down and insert the R-Series receiver through the rectangular cut-out as shown. 2. Align the two holes in the bottom of each receiver with the two holes in the bracket. Secure the receiver to the bracket with the 2 #6 Plastite screws provided.
600 Cecil Street, Buchanan, MI 49107 800/234-6831, 616/695-6831, 616/695-1304 Fax MANUAL - R100 Series Wireless ©Telex Communications, Inc. 1999 • Litho in U.S.A.
