User guide

4
Remote control (Diagram 2, page 15)
1. Input selector CD, TUNER, TAPE, DVD, VCR, HT
2. Mute on / off (Press for 1-2 sec. to set into Stdby)
3. Volume up
4. Volume down
Front panel (Diagram 3, page 15)
The main switch is located in the center of the lower part of the front
panel. In daily operation, switch off the ECI 5 MKII by using the MUTE
button on the remote control. If the ECI 5 MKII has been switched off,
allow two hours of warm-up for optimal sonic performance. When the
ECI 5 MKII is not to be used for a long period of time, use the main
switch to turn the unit off. Then disconnect the AC main cord for maxi-
mum safety.
Navigator window (Diagram 3, page 15)
The six inputs is avaliable:
TAPE, TUNER, CD, HT, VCR, DVD
In case of operating errors the display will inform of the fault status.
The following faults may occur:
- Temperature fault - Internal temperature limit exceeded.
- DC fault Right - DC voltage on right output.
- DC fault Left - DC voltage on left output
- Overload Left - Output overload left channel
- Overload Right - Output overload right channel
To reset any fault turn off the main power switch and then power up
again as normal.
ENG