User guide

5
Replacing a blown main fuse (Diagram 5, page 15)
The main fuse is located in a small drawer inside the AC inlet of the unit.
If, for some reason the fuse is blown, turn the unit off, and remove the
AC cord from the AC inlet. Open the drawer with a small screwdriver
and remove the blown fuse. The spare fuse is located inside a holder in
front of the main fuse.
1. Remove the spare fuse gently by pushing it sideways out of its holder.
2. Insert the spare fuse as the active fuse.
3. Push the drawer gently back to closed position.
4. Re-insert the AC cord and turn the unit on.
Never replace the fuse with other values than indicated on the unit!
Replacing remote control batteries (Diagram 4, page 15)
To replace the battery, lift the cover off, and insert a fresh set of batter-
ies. Be careful to follow the + and - polarity indications at the bottom of
the battery compartment.
Battery type: 2 x LR03 / AAA: 1.5Volts
Input configurations (Diagram 6, page 15)
XLR input: 1 = ground 2 = positive 3 = negative
RCA: Center = positive Circle = ground.
Output configurations (Diagram 6, 15 and 1, pg 14)
XLR output: 1 = ground 2 = positive 3 = negative
Speaker: Red = positive Black or White = ground
ECP5XLR:
RCA to XLR adapter: 1 & 3; ground and negative = shorted 2 = positive
ENG