Owner`s manual

ENG

Updating software and programming the ECT 4

ECT 4 is a universal remote control that also are able to control other IR

devices. To setup, please download and install the "Remote Configtool"

program. The installation file is available on our website at the

"Downloads - Firmware" area. Once the configuration program is installed

please follow the following steps:

1. Connect your ECT 4 to a PC or laptop

using the USB cable. Don't use the docking

station. The docking station is only for charg-

ing the battery.

2. Once connected, press the "Settings" button

and select "System information".

3. Press the "red" button ( image 1). You will

see the message "Connecting, Please wait!".

When the message is changed to "Connected.

Please proceed." Go to the next step.

4. Start the "Remote configtool" program and

press the button "Connect".

5. The main menu screen will be displayed. Please select the "brand" and

"Type" of IR device which you would like to add and press the Ok button.

6. Now you are able to program the buttons. The buttons marked with a

green color is automatically assigned buttons. You can also program any

buttons which to highlighted.

7. Press the "Add device" button.

8. Enter the name of the new device.

9. After you have added all devices , press the "write info" button.

10. Press the "Send to remote" button to complete the programming.

11. The message "Data successfully transmitted" will be displayed and the

remote control will re-boot automatically.

12. Now you can find your newly added device under the "Device"

selection menu.

Updating the ECT 4 firmware

1. For updating the firmware please follow the steps 1-4 from the "Remote

Configtool program" above.

2. Press the button "Update". The information about current firmware

and new firmware will be displayed. Press the "Start update" button for

upgrading the firmware.

ECI 6

image 1