Owner`s manual

ENG

ECT 4 Remote Control

Start Pairing

To be able to use the ECI 6DS with ECT 4 the two devices have to be

paired once. In the pairing process the devices exchange some necessary

data like device ID, RF address, etc. After pairing success, ECI 6DS will be

added to the device selection screen of the ECT 4 and can be used. Pairing

mode has to be started on both ECI 6DS and ECT 4. In addition, ECT 4

and ECI 6DS have to be in close proximity to each other. Pairing can be

canceled by pressing “Go back”, “Stop” or “Navigate left”. Hotkeys,

“Zone selection” and “System” key work as well.

Pairing procedure

1. To start the pairing procedure:

Press button , select "Start pairing" and

press the "Enter" button.

The following screen will be displayed (image 1)

2. Turn on the main switch of ECI 6DS immedi-

ately after pressing "Enter" on ECT 4. (image 2)

3. When pairing is successful, set the name of

the device found.

If there is no response in time, you will be

informed (image 3) and can try the pairing pro-

cedure again. Turn of the ECI 6DS and repeat

the procedure from the beginning.

ECT 4 Remote Control

image 2

image 1

image 3