User manual
- 11 -
CONNECTING POWER
The 1.8" Jumbo Alarm Clock Radio is equipped with an "AUTO TIME SET" feature. When
power is connected, the clock display will ash '2' which is TIME ZONE 2 (Eastern time) and
the default TIME ZONE setting. The correct time will be displayed, unless you are in another
time zone.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to conrm your selection.
To change your time zone upon setup:
• Press or DST/HA-°C °F until your own time zone appears on the
display; press ONCE to conrm your selection.
To change your time zone after setup:
• Press and hold the SNOOZE/SLEEP/DIM button until numbers ash.
• Press or DST/HA-°C °F until your own time zone appears on the
display; press ONCE to conrm your selection.
There are 8 programmed times zones:
BATTERY BACKUP
This alarm clock is equipped with a battery backup feature. This feature will restore your
alarm clock settings in the event of a power outage. The 3V, CR2032 Flat Lithium battery is
pre-installed at the factory, however, should you need to replace the battery, please read
the following instructions.
ATTENTION
• When replacing the battery, do not disconnect AC plug from AC outlet. Otherwise, current time and alarm will be initialized.
• Do not plug or unplug the power cable if you have wet hands.
• If you are not planning to use the unit for an extended period of time, disconnect the power cable from the wall outlet.
• Do not pull on the cord! You may damage the power cord and may cause an electric shock when disconnecting the
power cord from the wall outlet. Pull rmly at the base of the plug.
OPERATING INSTRUCTIONS
Zone 0 - Newfoundland time
Zone 1 - Atlantic time
Zone 2 - Eastern time (default)
Zone 3 - Central time
Zone 4 - Mountain time
Zone 5 - Pacic time
Zone 6 - Yukon time
Zone 7 - Hawaiian time