User manual

- 11 -
If you experience a problem with this unit, check the chart below before calling for service.
SYMPTOM POSSBILE CAUSE POSSIBLE SOLUTION
GENERAL
Power does not come on. AC cord not plugged in. Insert plug rmly into AC outlet.
RADIO
No Sound. Power is not on. Press POWER to turn the unit on.
VOLUME control at minimum
position.
Turn the VOLUME control up.
Noise or sound distorted
on AM or FM.
AM-interference from trafc. Tune the radio for better AM
reception.
FM-antenna wire not extended. Extend antenna wire.
Radio does not turn off
with SLEEP feature.
Power is not turned off. Press POWER to turn the unit off
before activation sleep.
CLOCK
Incorrect Time. Batteries inserted incorrectly,
no connected or dead.
Check batteries.
Clock not set. Set the clock.
Alarm does not turn on. Alarm is not set to turn on. Press ALARM ON/OFF to turn the
alarm on.
Clock is not set. Set the clock.
Alarm time is not set. Set alarm time.
Precautions
1. Always turn o the unit after use.
2. Keep the unit away from magnetic objects, water or heat sources.
3. Use a clean soft cloth moistened with lukewarm water to clean the cabinet. Never
use chemical cleaners that could damage the nish of the unit.
4. Disconnect the unit from any power sources before cleaning.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates,uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
CARE AND MAINTENANCE
TROUBLESHOOTING