Datasheet

Page 1
CYL
Cyanolube
CYL is a one part cyanoacrylate adhesive which offers fast cure speed together with high bond strength. The
adhesive does not require mixing or heating and can be cured in anaerobic conditions.
 Low viscosity, solvent-free adhesive; easy to use
 Cures in seconds upon exposure to traces of moisture/humidity or alkalinity
 Bonds a wide range of plastics and rubbers; including nitrile, neoprene, ABS, PVC, polyacetal, etc.
 Also bonds a wide range of metals in under 5 seconds; including steel, aluminium, copper and brass
Typical Properties
Liquid Properties: Colour: Clear
Flash Point: > 85°C
Cure Speed: 1 - 5 seconds
Viscosity (mPa s @ 20°C): 20
Density (g/ml): 1.06
Operating Temperature Range: -60 to 90°C
Cured Properties: Full Cure Time: 24 hours
Tensile Strength (N/mm
2
): 25 - 30
Tensile Shear Strength (N/mm
2
): 15
Description Packaging Order Code Shelf Life
Cyanolube 5g in 6 pack CYL05BE 12 months
Directions for Use
For optimum results, clean and abrade the surfaces to be bonded and make sure they are free from dirt, dust
and contamination (such as mould release agents). Apply a thin film or drop of CYL to one surface only and
bring the parts together, holding firmly for a few seconds. One drop will bond approximately 25mm
2
.
Revision 2: Nov 2017