Datasheet

Page 1

NSCP

Nickel Screening Compound - Plus

NSCP is an electrically conductive coating based on nickel powder in a thermoplastic resin. It is an extremely

efficient EMI/RFI screening coating that will adhere to a wide variety of substrates and can be used to coat

cabinets for a variety of electronic and electrical housings. The coating becomes touch dry 5 minutes after

application and achieves maximum conductivity after 24 hours.

• Excellent electrical properties; ideal for EMI/RFI shielding applications

• Fast drying at room temperature and provides good coverage; coats complex shapes

• Good adhesion to a wide variety of surfaces; can be applied to ABS and other plastics – testing advised

• Suitable for a wide variety of applications; for higher electrical conductivity please see Electrolube SCP

Approvals RoHS-2 Compliant (2011/65/EU): Yes

Liquid Properties: Colour Dark Grey

Surface Resistivity (Ohms per sq. @ 50µm) 0.3 - 0.7

Density (g/ml @ 20°C) 1.2

Touch Dry Time (@ 20°C) 5 minutes

Cure Time (@ 20°C) 24 Hours

Cure Time (@ 60°C) 2 Hours

Flash Point (°C) 17

Viscosity (mPa s @ 20°C) 2300

Approximate Coverage per Litre (@ 50µm) 1.50m

(400ml Aerosol)

5.60m

(Bulk)

Cured Properties: Adhesion (Cross Hatch Test BS3900E6) Excellent

Pencil Hardness 9H

Operating Temperature Range (°C) -40 - +95

Frequency (MHz) 20 60 250 500

Attenuation (dB) 62 65 62 55

Description Packing Order Code Shelf Life

Nickel Screening Compound Plus 400ml Aerosol NSCP400H 36 Months

5 Litre Bulk NSCP05L 36 Months

NSCP Thinners 5 Litre Bulk NSCPT05L 36 Months

PAGE 1
Page 1 NSCP Nickel Screening Compound - Plus NSCP is an electrically conductive coating based on nickel powder in a thermoplastic resin. It is an extremely efficient EMI/RFI screening coating that will adhere to a wide variety of substrates and can be used to coat cabinets for a variety of electronic and electrical housings. The coating becomes touch dry 5 minutes after application and achieves maximum conductivity after 24 hours.
PAGE 2
Page 2 Directions for Use Aerosol: Shake thoroughly before use; a minimum of 2 minutes is recommended. Ensure surfaces are free from dust, dirt and grease. For some substrates e.g. polypropylene a suitable primer may be necessary; please consult Electrolube Technical Department. Holding aerosol in upright position apply in light even strokes from side to side. More than one coat may be necessary to achieve desired specification. After use invert can and spray until nozzle is clear.