Installation Instructions

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS

9.4

Adjust Low Settings on Surface

Burners

To adjust the low setting of surface burners:

1. Push in and turn control to LITE until burner ignites.

2. Quickly turn knob to LOWEST POSITION.

3. If burner goes out, reset control to OFF.

4. Remove the surface burner control knob and

decorative ring.

5. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased by turning the screw.

6. Adjust ame until you can quickly turn knob from the

sparking position to the lowest ame position without

extinguishing the ame. Flame should be as small as

possible without going out.

Notes:

• Air mixture adjustment is not required on surface

burners.

• Some models have two ames on each burner. The

center ame on these burners is not adjustable.

9.3

Check Ignition on Surface

Burners

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks and range has been connected to

electric power. To check for proper lighting:

1. Push in and turn a surface burner knob to the

sparking position. All electronic surface ignitors will

spark at the same time. Only the burner you are

turning on will ignite.

2. The surface burner should light once the ow of gas

reached the surface burner. Each burner should light

within four (4) seconds in normal operation after air

has been purged from supply lines. Visually check

that burner has lit.

3. Once the burner lights, the control knob should be

rotated out of the LITE position.

Turn on each of the surface burners and check to see

that they light properly and that the ames are even.

Adjust settings if necessary.

Figure 30: Turn to adjust surface ame