LI 1270 E ................................................ .............................................
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Safety instructions Product description Control panel First use Personalisation Daily use Helpful hints and tips 2 3 4 6 8 8 8 11 Washing programmes 13 Consumption values 15 Care and cleaning 16 What to do if... 19 Technical data 21 Installation 22 Environment concerns 25 Building in 26 Subject to change without notice.
electrolux 3 • Obey the maximum load volume of 7 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
electrolux • The first time you use the appliance, make sure that there is no leakage. Use Warning! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household environment. • Obey the safety instructions on the detergent packaging. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Do not touch the glass of the door while a programme operates. The glass can be hot.
electrolux 5 5 Drain pump 6 Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme.
electrolux CONTROL PANEL Below is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot light and the display. These are presented by relevant numbers on the following pages. 1 2 1 Programme selector dial 2 TEMPERATURE button (Temp.
electrolux 7 1 hour up to a maximum of 20 hours by means of this button. Start Pause This button allows you to start or to interrupt the selected programme. Door locked pilot light The pilot light 9 illuminates when the programme starts and indicates if the door can be opened: • light on: the door cannot be opened. The machine in working or has stopped with water left in the tub. • light off: the door can be opened. The programme is finished or the water has been emptied out.
electrolux 7.4: Soil degree icons • Intensive • Normal • Daily • Light • Quick • Super Quick • Refresh • Super Refresh When selecting a programme on the display appears an icon indicating the degree of soiling automatically proposed by the machine. (see «Child Safe7.5: Child safety lock ty Lock» paragraph). Table of symbols = Cold Wash = No Spin = Door locked └ ┘ = Child Lock FIRST USE • Ensure that the electrical and water connections comply with the installation instructions.
electrolux 9 Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartor in the appropriate compartment ment if the selected programme/option it requires (see more details in «Detergent dispenser drawer»). to reset programme/Switching the machine off. At the end of the programme the selec, tor dial must be turned to position to switch the machine off.
electrolux For compatibility among the washing programmes and the options see chapter «Washing Programmes». Select the Delay Start by pressing button 6 Before you start the programme, if you wish to delay the start, press the button 6 repeatedly, to select the desired delay. The relevant pilot light goes on. The selected delay time value (up to 20 hours) will appear on the display a few seconds, then the duration of the programme will appear again.
electrolux 11 by pressing the button 8 again. The washing water in the tub will be not emptied out. Interrupting a programme Press the button 8 to interrupt a programme which is running, the corresponding green pilot light starts blinking. Press the button again to restart the programme. Cancelling a programme to cancel a proTurn the selector dial to gramme which is running. You can select now a new programme.
electrolux Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times.
electrolux 13 WASHING PROGRAMMES Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options Cotoni 90° - Cold Main wash - Rinses Maximum spin speed 1200 rpm Max. load 7 kg - Reduced load 3 kg 1) White and coloured cotton (normally soiled items). SPIN NO SPIN EASY IRON EXTRA RINSE TIME MANAGER Cotoni + Prelavaggio 90° - Cold Prewash2) - Main wash - Rinses Maximum spin speed 1200 rpm Max.
electrolux Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Risciacqui Rinses Maximum spin speed 1200 rpm Max. load 7 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin. The spin speed can be reduced. Options SPIN NO SPIN EASY IRON EXTRA RINSE Lingerie 40° - Cold Main wash - Rinses Maximum spin speed 900 rpm Max.
electrolux 15 Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Detergent Compartment Options SPIN NO SPIN EASY IRON EXTRA RINSE Cotoni Eco 90° - 40°3) Main wash - Rinses Maximum spin speed 1200 rpm Max. load 7 kg White and fast coloured cotton. This programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended.
electrolux Off Mode (W) Left On Mode (W) 0.98 0.10 The information given in the charts above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. CARE AND CLEANING Warning! You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine.
electrolux 17 Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. 2. If it is necessary, wait until the water has cooled down. Important! Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. 1. Remove any rust deposits on the drum with a cleaning agent for stainless steel. 2. Run a washing cycle without any washing to clean off any cleaning agent residues.
electrolux 6. Remove foreign bodies and fluff from the filter seat and from the pump impeller. Check carefully whether the pump impeller rotates (it rotates jerkily). If it doesn’t rotate, please contact your Service Centre. has finished the cycle, and is empty. When refitting the pump cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.
electrolux 19 5. When you intend to start the machine up again, make sure that the room temperature is above 0°C. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: 1. pull out the plug from the power socket; 2. close the water tap; 3. if necessary, wait until the water has cooled down; 4. place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl.
electrolux Problem Possible cause/Solution The machine does not fill: The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. • Clean the water inlet filters (See "Cleaning the water inlet filters" for more details). The door is not properly closed. • Close firmly the door. The machine fills then empties immediately: The end of the drain hose is too low.
electrolux 21 Problem Possible cause/Solution The door will not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait until the pilot light 9 has gone off. There is water in the drum. • Select drain or spin programme to empty out the water. The machine vibrates or is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance.
electrolux Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Level of protection against ingress of solid particles and moisture IPX4 Water supply 1) Cold water Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. INSTALLATION Unpacking All transit bolts and packing must be removed before using the appliance.
electrolux 23 3. Unscrew and remove the central rear bolt A with the supplied spanner . Slide out the relevant plastic spacer. 5. Remove the bracket D and tighten up the six smaller bolts C. D 4. Unscrew and remove the two large rear bolts B and the six smaller bolts C.
electrolux 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. levelled the appliance, tighten the lock nuts. Water inlet The inlet hose is supplied with the appliance and can be found inside the machine drum. Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance.
electrolux 25 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
electrolux This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
electrolux 27 A (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet B on the appliance (Fig. 6). Fig. 4 Warning! Do not remove the screw C. 1 2 Fig. 6 A B c) Mounting the door Fix the hinges to the appliance by means of the M5x15 screws. The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw, adjust the door and tighten the screw A again (Fig. 5).
www.electrolux.