RWF 1293 FFW ................................................ .............................................
www.electrolux.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.electrolux.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.electrolux.com 3. PRODUCT DESCRIPTION 1 2 2 Detergent dispenser 3 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump filter 4 7 Feet for the appliance level 3.1 Fixing plate kit (4055171146) 5 Available from your authorized dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. Follow the instructions supplied with the kit. 6 7 1 Worktop 3.2 Child safety device When you activate this device, you cannot close the door.
ENGLISH 7 8 Easy iron touchpad 5 Prewash touchpad (Stiro Facile) (Prelavaggio) 9 Start pause touchpad 6 Delay start touchpad (Avvio/Pausa) (Partenza Ritardata) 10 Time Manager touchpads 7 Extra rinse touchpad (Extra Risciacquo) A) The time area: 4.1 Display A B C B) C) D) E D E) – Programme time. – The alarm codes. Refer to the chapter “Troubleshooting” for their description. – The level of the Time Manager . The Delay Start indicator. The Child Lock indicator.
www.electrolux.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Risciacquo Cold To rinse and spin the laundry. All fabrics. 9 kg, 1200 rpm Centrifuga/Scarico To spin the laundry and to drain the water in the drum. All fabrics. 9 kg, 1200 rpm A mano 40 °C – Cold Special programme for very delicate items, as lingerie, bras and underwear etc.
ENGLISH 9 Programme Risciacquo ■ ■ Centrifuga/Scarico1) ■ ■ ■ ■ A mano ■ ■ Seta ■ ■ Tende ■ ■ Piumoni ■ Outdoor ■ ■ ■ Super Rapido ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 1) If you set No Spin option the only drain phase is available. 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity.
www.electrolux.com Programmes Standard 40 °C cotton Load (Kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)1) 4.5 0.681 46 200 53 Off Mode (W) Left On Mode (W) 0.48 0.48 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 1) At the end of spin phase. 7. OPTIONS 7.1 Temperature Set this option to change the default temperature.
ENGLISH The appliance decreases the spin speed, uses more water and adapt the programme duration to the type of laundry. The related indicator comes on. 7.7 Time Manager Sintetici Delicati Scuri Tende ■ ■ ■ ■ ■ 7.10 Acoustic signals ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Indicator ■ ■ ■ 2) 7.9 Permanent extra rinse With this option you can permanently have an extra rinse when you set a new programme.
www.electrolux.com 9. DAILY USE 9.1 Loading the laundry 1. 2. 3. Open the appliance door. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Close the door. CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner.
ENGLISH 13 Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Setting a programme 1. 2. Turn the programme knob and set the programme: – The indicator flashes.
www.electrolux.com After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. • Press again and again until the display shows the delay you want to set. The related indicator comes on the display. : • Press – The appliance starts the countdown. – When the countdown is completed, the programme starts automatically.
ENGLISH 2. 3. 4. Press . The appliance drains the water and spins. When the programme is completed and the door lock indicator goes off, you can open the door. Turn the programme knob to deactivate the appliance. to The appliance drains and spins automatically after approximately 18 hours (except for Wool programme). 15 the appliance, the energy saving status activates. The energy saving status decreases the energy consumption when the appliance is on the stand by.
www.electrolux.com 10.4 Ecological hints • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of the detergent, check the water hardness of your domestic system a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener.
ENGLISH 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 2. 1.
www.electrolux.com 3. 4. 1 5. 6. 1 2 7. 8. 9.
ENGLISH 19 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
www.electrolux.com 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. • - The appliance door is open or not closed correctly. Please check the door! • - The mains supply is unstable. Wait until the mains supply is stable. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water properly.
ENGLISH Problem 21 Possible solution Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor.
www.electrolux.com Problem Possible solution Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Service. 13.
ENGLISH 23
132910190-A-322013 www.electrolux.