RWF 1408 WDL ................................................ .............................................
www.electrolux.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.electrolux.com 2.1 Installation • Remove all the packaging and the transit bolts. • Keep the transit bolts. When you move the appliance again you must block the drum. • Do not install or use a damaged appliance. • Do not install or use the appliance where the temperature is less than 0 °C or where it is exposed to the weather. • Obey the installation instruction supplied with the appliance. • Make sure that the floor where you install the appliance is flat, stable, heat resistant and clean.
ENGLISH not use abrasive products, abrasive cleaning pads, solvents or metal objects. 2.4 Internal light WARNING! Risk of injury. Visible LED radiation, do not look directly into the beam. To replace the internal light, contact the Service. 5 2.5 Disposal WARNING! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent children and pets to get closed in the appliance. 3.
www.electrolux.com 4.
ENGLISH G) H) I) J) : Extra Rinse indicator. : The indicator of child lock on when you activate this device . The text bar. The text bar shows the programme status, alarm messages and other messages that help you to operate with the appliance. : Door locked indicator. You cannot open the appliance door when the indicator is on. 7 You can open the door only when the indicator goes off. K) The spin area: – : Spin speed indicator. – – – : No Spin indicator. : Rinse Hold indicator.
www.electrolux.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Vopore - Rrefresh Steam programme for cotton and synthetic This programme removes odours from the laundry. Others Press again and again this touchpad until you set the desired programme: 14 Min. 30 °C Synthetic and mixed fabric items. Light soil and items to freshen up. 1.5 kg, 800 rpm Sport 30 °C Synthetic and delicate items. Light soil or items or items to refresh. 2.
ENGLISH 9 Programme 14 Min. ■ ■ ■ Sport ■ ■ Jeans ■ ■ ■ Risciacquo ■ ■ ■ Centrifuga/Scarico ■ ■1) ■ ■ ■ ■ ■ ■ ■ ■ 1) Only the drain phase is available. 6. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature.
www.electrolux.com 7. OPTIONS 7.1 Temperature 7.3 Prewash Set this option to change the default temperature. Indicator = cold water. The display shows the set temperature. With this option you can add a prewash phase to a washing programme. Use this option for heavy soil. When you set this option the programme duration increases. The related indicator comes on. 7.2 Spin With this option you can decrease the default spin speed. The display shows the indicator of the set speed.
3) ■ ■ ■ ■ ■2) ■2) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■2) ■ ■2) ■2) 11 7.8 My Favourite+ Eco Indicator ENGLISH ■ 1) Shortest: to fresh the laundry. 2) Programme default duration. 3) Longest: for laundry with heavy soil. Eco Info The Eco Info stripes (available only in cotton and synthetics programmes) show the efficiency of the washing programme in terms of energy saving: • 6 stripes: the most efficient setting to optimize the washing programme performance. • 1 stripe: the less efficient setting.
www.electrolux.com If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 8. BEFORE FIRST USE 1. 2. 3. Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. Put a small quantity of detergent in the compartment for washing phase. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 8.
ENGLISH 13 9. DAILY USE 9.1 Activating the appliance and setting a programme For a correct operation of the weight sensor, activate the appliance and set the programme BEFORE you put the laundry in the drum. 1. 2. 3. Press the AutoOff button to activate or deactivate the appliance. A tune sounds when the appliance is activated. Press one of the programme touchpad to set the necessary washing programme: – The related programme indicator comes on. flashes.
www.electrolux.com 9.3 Using detergent and additives • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Compartment for bleach agent. Flap for powder or liquid detergent. Liquid or powder detergent 1. 2.
ENGLISH 3. 15 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 9.
www.electrolux.com 9.7 Interrupting a programme and changing the options You can change only some options before they operate. 1. Press . The indicator flashes. 2. Change the options. 3. Press again. The programme continues. 9.8 Cancelling a programme 1. 2. Press the button for some seconds to cancel the programme and to deactivate the appliance. Press the same button again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. 9.
ENGLISH The display shows the end of the last set programme. 17 Turn the programme knob to set a new cycle. 10. HINTS AND TIPS 10.1 The laundry load 10.3 Detergents and additives • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times.
www.electrolux.com 11. CARE AND CLEANING WARNING! Before maintenance, disconnect the appliance from the mains supply. To remove rust particles use only special products for washing machine. Do this separately from the laundry wash. Always obey the instructions that you find on the packaging of the product. 11.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. 11.
ENGLISH 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 2. 1. 2 1 3. 4.
www.electrolux.com 5. 6. 1 2 7. 8. 1 2 9.
ENGLISH 21 11.7 Cleaning the inlet hose and the valve filter 1. 2. 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. 2. 3.
www.electrolux.com 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • Check the tap - The appliance does not fill with water. • Check drain filter - The appliance does not drain the water. • Check the door - The appliance door is open or not closed correctly.
ENGLISH Problem 23 Possible solution Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again.
www.electrolux.com 13.
ENGLISH 25
www.electrolux.
ENGLISH 27
132921580-A-252012 www.electrolux.
