Service manual

Section 2 Installation Information
2-17
Reattaching the Door
1. Holding the door in both hands, squarely insert the
“T” post on the back of the hinge into the “T” slot
on the front panel and lower it to align the mounting
holes. (See Figure 2-30)
2. Rest the opening of the inner door at a 90 degree
angle on the “shoulders” of the hinge cutout gate.
Pivot the inner door down onto the outer door.
(See Figure 2-31)
Figure 2-30.
Figure 2-31.
“T” Slot In
Front Panel
“T” Post On
Door Hinge
3. Close the door and test operation of hinge, strike
and latch. (See Figure 2-32)
Figure 2-32.
Correctly installed hinge screws will press hinge flush
to front panel. Any gap between hinge and front panel
will cause misalignment of strike to latch.
NOTE