Service manual

Section 2 Installation Information
2-21
Figure 2-38.
The Gallery Series dryers are designed so the door swing
may be reversed at any time without additional parts.
Conversion is accomplished by transferring hinges to the
opposite side of the cabinet.
“Solid Door” Reversal Instructions:
1. Open the dryer door. Remove the four hinge hole
plugs from the left side of the door opening. Retain
the plugs for use later.
2. Remove the four screws that secure the door hinges
to the dryer front panel (see below). Hold the door
firmly before removing the last two screws.
(See Figure 2-38)
3. Rotate the door 180° and reinstall the door hinges
to the dryer front panel with the four screws.
4. Install the four hinge hole plugs in the open screw
holes on the right side of the door opening.
Window Door Reversal Instructions:
1. Follow steps 1 and 2 from above.
2. Install the plugs from Step 1 into the holes left by
removing the door in Step 2.
3. Remove the two handle hole plugs from the door.
Retain the plugs for use later. (See Figure 2-39)
4. Remove the two handle screws and remove the
handle by pulling straight out from door.
5. Install the plugs from Step 3 into the holes left by
removing the handle screws in Step 4.
6. Lay the door on a flat surface and support the edges
of the door to keep it from turning. Apply moderate
downward pressure on the lens with both hands and
rotate it 180°. Align the handle holes in the lens
with the handle holes in the transition ring.
(See Figure 2-40)
7. Install the handle and screws removed in Step 4.
A plastic knife may be needed to help pull out the
plugs. Use caution not to scratch the paint.
NOTE
A plastic knife may be needed to help pull out the
plugs. Use caution not to scratch the paint.
NOTE
Remove one screw from each of the two hinges first.
NOTE
Screws
Screws
Figure 2-40.
Figure 2-39.
Screws
Hole
Plugs