Service manual

Affinity Series Section 3 Electronic Control
3-1
Affinity Control Panel Layout
Operating Steps
1. Prepare items for drying.
2. Check that lint filter is clean and in place.
3. Load the dryer. If desired, add a dryer fabric softener sheet. Close the door.
4. Select the appropriate cycle and settings for each load.
• Turn the Cycle Selector knob to select the cycle. The estimated drying time will be displayed.
• A suitable drying temperature, dryness level and options will automatically be indicated for each cycle. See
the “Dryer Setting Chart” for more details.
• To change the temperature and dryness level, press TEMPERATURE or DRYNESS until desired selections are
made.
• To select or delete an option, press OPTIONS; then, while indicator is blinking, press SELECT. The indicator
will light when the option has been selected. The indicator will no longer be lit when the option has been
deleted.
• If a temperature, dryness level or option is not available for a cycle, it will not light.
• Adjustments to the cycle will be remembered each time that cycle is selected in the future.
• To return to factory settings, press START/PAUSE and SELECT at the same time and hold until signal sounds.
5. Press Start/Pause to begin the cycle.
• To pause the cycle press START/PAUSE. To resume the cycle, press START/PAUSE again.
• To stop or change the cycle, press CANCEL.
6. A signal will sound at the end of the cycle and periodically during Extended Tumble when the Signal option is
selected. When the cycle ends, remove items immediately and hang or fold.
7. Clean the lint screen after every load.
Cycle Selection
Turn the Cycle Selector knob to the desired cycle. For best results, follow the fabric care label instructions on items
to be dried. If the selection is changed after the cycle starts, the indicator lights will blink, the signal will beep and
“Err” will be displayed. To change the selection after the cycle has begun, press CANCEL before making another
choice. Just turning the knob to another selection will not change the cycle. The signal will beep and the status
lights will flash, but the original cycle will continue.
Cycles with Light
Indicators
User Interface Buttons
Cycle Selection Knob
LED Timer
Status
Lights
Temperatures with
Light Indicators
Dryness Level with
Light Indicators
Dryer Features with
Light Indicators
Figure 3-1. Affinity Control Panel