Service manual

Section 3 Electronic Control Affinity Series
3-4
Options
To select an option, press OPTIONS until the indicator
for the desired option flashes, then press SELECT. If an
option is not available for a cycle, the indicator will not
light. Follow the same steps to delete an option.
(See Figure 3-5)
Select Shrink Guard to lower the initial drying
temperature to protect fabrics from over dying.
Select Extended Tumble if the dried load might not
be removed promptly at the end of the cycle. The dry
load will continue tumbling without heat for 30 minutes
to help reduce wrinkling.
When the Signal is selected, a beep will be heard
periodically and at the end of the cycle. The signal has
an adjustable volume level or can be turned off. The
load may be removed any time during Extended Tumble.
Dryer Features
Control Lock
To avoid having someone accidentally start or stop the
dryer, press OPTIONS and SELECT at the same time and
hold for 10 seconds. “LOC” will be displayed. To remove
the control lock, press OPTIONS and SELECT again.
(See Figure 3-6)
Start/Pause
Press START/PAUSE to start, pause or restart a cycle.
“PAU” will be displayed alternately with the estimated
time remaining when the cycle is paused.
Cancel
Press CANCEL to stop the cycle.
Status Lights
The following indicators may be lighted during the cycle:
• Drying
• Cool Down
• Extended Tumble
Figure 3-5. Options
Shrink Guard Selected
Press Here To Scroll
Press Here To Select
Figure 3-6. Control Lock
Press Here To Lock Control