Use & care guide

Installation Instructions

NOTE

If you were able to install the “Y” connector directly to

the COLD water supply, please skip to step 8.

Water connection, continued

WATER INLET

ON DRYER

DIRECT CONNECTION

OR WITH EXTENSION

COLD WATER SUPPLY

HOSE TO WASHER

5 If your installation has room for the COLD water

supply to accept the “Y” connector directly, thread

the “Y” connector to the COLD water supply and

tighten it by hand until snug; then tighten it another

2/3 turn with pliers.

6 If there is not enough room to install the “Y”

connector directly, thread the short extension hose

onto the COLD water supply and tighten it by hand

until snug; then tighten it another 2/3 turn with

pliers.

7 Thread the “Y” connector to the short extension hose

and tighten it by hand until snug; then tighten it

another 2/3 turn with pliers.

8 Connect the COLD inlet hose for the washer to the

“Y” connector and tighten it by hand until snug; then

tighten it another 2/3 turn with pliers.

9 Connect the straight end of the long hose from the

kit to the other outlet on the “Y” connector and

snug it by hand. Connect the hose’s 90° coupling

to the brass water inlet on the back of the dryer

and tighten it by hand until snug. Tighten each

connection of the dryer inlet hose another 2/3 turn

with pliers.

10 Turn on the water and check for leaks at all

connections.