Use & care guide
20
Installation Instructions - Performing Installation Cycle
WARNING
FIRE HAZARD
Before operating the dryer, make sure the dryer area is
clear and free of combustible materials, gasoline, and
other fl ammable vapors. Also see that nothing (such as
boxes, clothing, etc.) obstructs the fl ow of combustion
and ventilation air.
If your dryer has this console:
If your dryer has this console:
Empty dryer’s drum and close door.1.
After you plug in the dryer the fi rst time: wake up the dryer by pressing the 2.
POWER
button (
3
), rotate cycle knob to cycle
one up from lower right position (
1
), and within 10 seconds, immediately and simultaneously press and hold both the far
right options button above the LED (
2a
) and the far right settings button under the LED (
2b
) for 5 seconds, or until the LED
display changes.
The LED window will display 3. (Install) and show estimated time of cycle completion. Press the START button (4). The
Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window may display
(Install Pass), meaning your new dryer is properly installed and ready for use. If it prompts an action such as
(Service Cord),
(No Gas), or (Call Service - 1-800-4-MY-HOME), review the
installation steps and make the necessary corrections before you attempt to use the dryer.
Your dryer will exit the 4.
Installation Cycle
and return to normal operation the next time you wake it up.
After you plug in the dryer the fi rst time, the dryer will power up on its own. Then follow the prompts on the touch screen 1.
LCD, including language selection.
The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window may 2.
display INSTALL PASS!, meaning your new dryer is properly installed and ready for use. If it prompts an action such as
SERVICE CORD, NO GAS, or CALL SERVICE - 1-800-4-MY-HOME, review the installation steps and make the necessary
corrections before you attempt to use the dryer.
Your dryer will exit the 3.
Installation Cycle
and return to normal operation the next time you wake it up.
Please read the 5.
Use & Care Guide
and enjoy your new premium dryer!
Please read the 4.
Use & Care Guide
and enjoy your new premium dryer!
NOTE
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
dryer through a drying cycle, press the POWER button to put the unit to sleep and then rewake it
immediately with the POWER button to continue the normal operating mode.
NOTE
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
dryer through a drying cycle, press the POWER button to put the unit to sleep and then rewake it
immediately with the POWER button to continue the normal operating mode.
With your dryer in fi nal location, perform an Installation Cycle to assist in proper installation.
1
2a
2b
34
IMPORTANT
On gas dryers, before the burner will light, it is necessary
for the gas line to be bled of air. If the burner does
not light within 45 seconds the fi rst time the dryer is
turned on, the safety switch will shut the burner off . If
this happens, press POWER and wait 5 minutes before
making another attempt to light.