Wiring diagram

SERVICE DATA SHEET
41013567
WINE COOLER - BEVERAGE CENTER - R134a
IMPORTANT SAFETY NOTE
The information provided herein is designed to assist
qualified repair personnel only. Untrained persons should not
attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
IMPORTANT
If any green grounding wires are removed during servicing,
they must be returned to their original position and properly
secured.
CAUTION
All electrical parts and wiring must be shielded from torch
ame. DO NOT allow torch to touch insulation; it will char
at 200°F and ash ignite (burn) at 500°F. Excessive heat
will distort the plastic liner.
IMPORTANT: PLEASE RETURN THIS SHEET
TO IT'S ORIGINAL LOCATION.
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS
AT MID-POINT CONTROL SETTINGS
Type A with Run/Start
Capacitor
65° (18°C) Ambient 90° (32°C) Ambient
Operating Time 8 to 15% (wine cooler)
15 to 35% (beverage center)
20 to 40% (wine cooler)
35 to 55% (beverage center)
Wine Cooler Temperature 40°F to 65°F 40°F to 65°F
Beverage Center
Temperature
34°F to 42°F 34°F to 42°F
Low Side Pressure (cut-in)
25 to 50 psig
172 to 345 kPa
25 to 50 psig
172 to 345 kPa
Low Side Pressure (cut-out)
0 to 10 psig
0 to 69 kPa
0 to 10 psig
0 to 69 kPa
High Side Pressure
(last 1/3 cycle)
95 to 125 psig
655 to 862 kPa
130 to 175 psig
896 to 1207 kPa
Wattage (last 1/3 cycle) 55 to 80 55 to 80
Amps (running) .45 to .85 .45 to .85
Base voltage 115 vac (127 vac max)
CONDENSER FAN MOTOR
Watts RPM Amps
4.1 1280 0.06
EVAPORATOR FAN MOTOR
1.08 2550 0.09
NOTE
Your Electrolux wine cooler / beverage center has been
designed for either free-standing or built-in installation.
When built-in, your wine cooler does not require additional
air space for top, sides or rear. In either case, the front
grille must NOT be obstructed.
To ease unit installation and removal, it is recommended
that the cabinet rough opening dimensions be increased by
at least ¼ inch over the dimensions given for the unit.
All units require zero clearance when installed flush with a
cabinet or wall. Electrolux stainless steel models require a
minimum 2½ inch handle clearance when installed against
a wall or cabinet that extends beyond the front edge of the
unit.
Unit Dimensions
Width Height Depth
23
7
⁄8 inch 33
3
⁄4 to 34
3
⁄4 inch 26
3
⁄8 inch
To p
View
Side
View
Front
View
3
11
⁄32"
23
7
⁄8"
26
3
⁄8"
23
23
⁄32"
21½"
33
3
⁄4"
Adjustable to
34
3
⁄4"
2½"
46
13
⁄32"
2
3
⁄4"