3531 WK-m 374 4273 16 / 0205 INSTRUCTION BOOK From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world.
Congratulations from AEG Dear Customer, Congratulations with your new Hob. It is important that you become familiar with the functions and features of the Hob. You should therefore read these operating instructions as they will help you get the most out of your new Hob. Pay extra attention to sections marked . These are warning texts to help you avoid accidents. Keep the operating instructions.
Table of contents Contents Page no For the user Your new appliance ...................................................................................... 2 Safety information ........................................................................................ 4 Description of the product ......................................................................... 6 Operatings instructions ............................................................................... 7 Burner ring........................
Safety information Never use plastic or aluminium dishes on the gas hob. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Never leave the gas hob unattended while deep fat frying, or heating fats and oils. Do not use or store flammable materials near this appliance.
Service Service Sympton: Solution: There is no spark when lighting the gas? Check whether the 240 V connection has been plugged in. The ground fault circuit relay way have switched off. The fuse has blown When the operating knob is released the gas ring goes out again? The operating knob has not been depressed long enough, or has not been depressed sufficiently. The gas ring burns very unevenly? Ensure the cover has been replaced correctly, e.g. after cleaning.
Description of the product Burner Technical data Type of gas Adjusted for natural gas: 1,0 kPa (test point pressure) Radio-noise reduction This unit observes the current EECdirective on radio noise reduction. Q = Nominal gas consumption NG: Wok burner: 13,0 MJ/h Total: 13,0 MJ/h Material: AUS/NZL: Convertible to universal LPG (Propane): 2,75 kPa (test point pressure).
Operatings instructions Burner markings Before leaving The pipe connections should be checked for leaks with soap and water. Do not use a naked flame for detecting checks. Test all burners on high and low flame for flame stability. Test the stability of the low flame when any nearby cupboard doors are used. When satisfied with the appliance, please instruct the user on the correct method of operation.
Burner cover/burner ring Together with the burner ring the burner cover forms a space where the final mixture of gas and air takes place in order to make the gas burn correctly. Burner ring Burner cover Correct Please note: It is consequently very important that the burner cover/ring is placed correctly on the burner. The burner ring has been provided with holes for the ignition electrode, and the thermo sensor.
For Universal LPG the regulator is fitted to the gas inlet of the appliance so that a pressure test point is available. The regulator should be disabled by adjusting the regulator adjusting screw to be fully screwed in, but do not remove the locking nut from the regulator. The supply pressure to the appliance is controlled by the regulator located on the LPG cylinder. This cylinder regulator should be adjusted to give a pressure of 2.
Ignitions 1. Depress and turn the control knob for the burner, the left to Max. flame 2. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. Is not possible to connect the unit to mains, a match may be used to ignite the burner 3. After starting the burner, press the control knob for approx. 10 seconds to activate the automatic thermo couple. 4.
Cleaning and maintenance Any adjoining wall surface situated within 200 mm from the edge of any hob burner must be a suitable noncombustible material for a height of 150 mm for the entire length of the hotplate. reinforcement beam to the table surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges.
Mounting Stainless steel surfaces This appliance must be installed by an authorised person. Perform daily cleaning with a slightly damp cloth. For more severe soiling, use a liquid cream. Always clean the steel in the direction of the steel finish. To ensure that the steel retains its shine, it is recommended that you use a polishing agent for stainless steel on a regular basis. Always polish in the direction of the steel finish (crosswise).