DL 4150 - CHDL 4150 HL 4150 - DL 6250 570 D - 5708 D Cooker Hood Cappa aspirante Campana extractora Exaustor Operating and Installation Instructions Istruzioni di montaggio ed uso Instrucciones de montaje y manejo Manual de Instruções
Contents 2 Safety warnings For the user For the installer 3 3 4 Description of the Appliance Extraction mode Recirculation mode 6 6 6 Control Panel 7 Maintenance and care Cleaning the hood Metal grease filter Removing the metal grease filter Charcoal filter Changing the light bulb 8 8 8 8 10 11 What to do if 12 Special accessories 13 Technical assistance service 13 Technical Specifications 14 Electrical connection Installation Removing the hood from cabinet Relocating the control unit (Onl
Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. The hot oil in the frying pan might ignite due to overheating.
For the installer When used as an extractor unit, the hood must be fitted with a hose having preferably the same diameter as the outlet hole. Only 5708 D: this model is equipped with two outlet hole. 2 hoses are therefore necessary for discharging the fumes.
aforementioned measures. When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: short and straight outlet hose keep bends in outlet hose to a minimum never install the hoses with an acute angle, they must always follow a gentle curve. keep the hose as large as possible (preferably the same diameter as the outlet hole).
Description of the Appliance The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter. In some models the charcoal filter is supplied. The hood, therefore, can be used immediately in the recirculation mode. We advise removing the charcoal filter to use the hood in the extraction mode.
Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The switches are located on the right-hand side of the hood.
Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
Hand washing Soak grease filters for about one hour in hot water with a little washing up liquid added, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry.
Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original charcoal filter (available from your local Service Force Centre). Replacing the charcoal filter Type 150 Note: this filter is already installed on model 570 D-m9. This filter cannot be cleaned or reused. As a general rule, the activated charcoal filter should be changed once every 4 months.
Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air.
Special accessories Charcoal filter Type 150 LONG LIFE Charcoal filter Type 150 Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.
Technical Specifications Model: DL4150 DL 6250 Maximum absorbed power: Motor absorption: Lighting (E14): Lighting (PL): Length of the cable: Electrical connection: 295 W 220 W 1 x 140 W 2 x 140 W 2 x 40 W 1 x 11 W 150 cm 150 cm 230 V 230 V CHDL4150 570 D HL 4150 220 W 1 x 140 W 2 x 40 W 150 cm 220-240 V 5708D 340 W 200 W 1 x 186 W 2 x 160 W 1 x 11 W 2 x 9 W 150 cm 150 cm 230 V 230 V A A= B= C= B 570 D 515 mm 510 mm 548 mm 5708 D 715 mm 710 mm 748 mm C Fig.
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board.
Installation - Fig. 8 Only 5708 D: this model is equipped with two outlet hole. 2 hoses are therefore necessary for discharging the fumes. If present, an opening for the easy passage of both hoses must be made in the top of the wall-unit. Drill the base of the wall unit to allow for passage of the hood body. Fig. 7. Drill the top of the wall unit to allow for passage of the exhaust pipe and the electrical cable. Fig. 7. Remove the grease filter (1).
3-F OK! OK! 5-C 4 5-C 6 6 7 7 7 7 2 1 2 Fig.
Removing the hood from cabinet Follow these steps: Remove the grease filter. Remove the 4 additional screws from the frame. Loosen the screws on the two fixing springs. Fig. 9. Fig. 9 Push a flat screwdriver into the hole for the fixing springs (right and left) and push each of the fixing springs inwards. Fig. 10. At the same time, pull the extractor hood (right and left) out of the cabinet. Re-install it as described above. Fig.
Relocating the control unit (Only 570 D - 5708 D) The control unit can be fitted at a different point (cladding, lighting facia, etc.). Remove the grease filter grill and the housing frame. 1. Loosen two screws and pull the control unit forwards out of the housing. Undo the socket connection. Caution: The socket connection cable is only long enough for a maximum distance of 40 cm! Fig. 11 2. Open the cable channel on the top side of the housing and pull the wire for the control unit through the opening.
From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de http://www.aeg.co.