A 803 K Operating instructions 0402 207.5080.
Fig 1 2
Dear customer, please read the instruction book and all additional information before using the appliance. It is most important that they should be retained with the appliance for future reference! 1. Warnings and directions These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance! This product is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product.
3. Storage of gas cylinders Liquid gas cylinders should never be stored in unventilated areas or below ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should not be exposed to temperatures in excess of 50°C. 4. Installation To be installed horizontally on a smooth, firm or any other appropriate surface. If necessary, adjust/align using a spirit level or a water-filled vessel. There should be a distance of at least 10cm between the back of the unit and any other object (wall).
To turn off (Fig. 1) - 3-way-switch (D) should be in position '0'. - Turn thermostat knob (A) anticlockwise to position '0' (a slight resistance will be felt just before this position). - Pull out mains plug. 7. D/C operation Do not use any additional form of energy (mains/gas). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. 12 V: maximum 15 amps; 24 V: maximum 7.5 amps. max. cable lengths Cable cross section 2.5 mm2 4.0 mm2 6.
8. Liquid gas operation Do not use any additional form of energy (mains/battery). The unit must not be connected to town or natural gas pipelines. It is only suitable for use with propane/butane gas (e.g. Calor Gas, Camping Gaz, Caravangas, etc). The refrigerator is equipped for a specific gas-pressure, corresponding to the standard pressure of the country in which it is sold. The rating-plate states the pressure which is correct.
11. Igniting the gas burner (Fig. 1/2) 3-way-switch (D) should be in position "0" Open gas cylinder or pressure regulating valve. Turn knob (F) to position 6. Turn knob (B) anticlockwise to the MAX position, press and hold down. After approximately 10 seconds, press knob (E) several times. After ignition, hold down knob (B) for a further 20-30 seconds before releasing. The flame can be controlled by aperture (C). Should no ignition occur, repeat the ignition process after 1 minute.
defrosting process. After defrosting, clean up the defrosted water with a clean cloth and clean the cooler containers as described in chapter 4. Should the unit be out of operation for a prolonged period, turn off unit and remove contents. After defrosting, the cooler should be cleaned carefully and dried. To avoid any unpleasant smells forming in the cooler, the lid should be left slightly open. 15.
- was a too large a quantity of food or drink stored at any one time? Food and drink should be so stored as to allow free air circulation. Do not use paper or plastic plates. Always keep containers for liquids sealed. When contacting our customer service department, please indicate the unit type, product number, serial number and type of defect. We accept responsibility for the perfect condition of the unit, the guarantee being in accordance with our garantee conditions. 18.
seal Fig 2 10
Printed by Xerox Hungary Ltd. Rev.: 2004. 02. 03.
