Modular refrigerator Connection kit Installation manual
electrolux.com.au CONNECTION KIT This connection kit is designed for use on the following top mount, bottom mount and single door refrigerators and freezers whose total body height is 1725 mm.
JOINED DIMENSIONS 50mm 50mm 50mm 50mm Wa Please note: Please note: 63mm Wa Wa D D D1 D1 63mm 30mm CABINET CABINET DOOR DOOR DOOR 30mm 30mm 30mm CABINET 30mm designed are designed Minimum Minimum Minimum MinimumDoors areDoors recommended recommended recommended recommended to sit proud to sit of proud of airspace airspace airspace airspace cabinetry cabinetry (not flush).(not flush).
electrolux.com.au BEFORE YOU BEGIN • Thoroughly inspect cabinets for any signs of damage before commencing installation. • If any damage is identified please contact Electrolux Service. • Check refrigerator recess dimensions and ensure that they provide at least the minimum clearance at the back, side and top as recommended on page 2. • The floor where the refrigerator is to be placed must be level, otherwise you will not be able to install your refrigerator properly.
CONNECTION KIT PACKAGE CONTENTS Item description qty ANC 1 Replacement foot base with M4 threaded holes 2x A02102702 2 Adjustable Foot Assembly LH 1x A02816701 RH 1x A02816702 3 Mounting M5 x 12 bolts 8x A04064701 4 M5 nuts 8x A04797101 5 Screw 8G x 1/2” type AB pan head phillips 4x 1449422 6 Top front bracket 1x A03972801 7 Screw trilobular M5 x 13 6x 811949402 8 Bottom rear bracket 1x A03979601 9 Bottom front bracket assembly - grey 1x A03973401 (includes ten
electrolux.com.au INSTALLATION 1.1- Required Tools • • 100mm 100mm Phillips head screwdriver 300mm 7mm socket wrench screwdriver 1.2 - Preliminary Operations 300mm 1.2.1 - General Preparation • Pull the appliances together • Adjust the front feet of the appliances to the same height and alignment Step 1 .2.
INSTALLATION (CONTINUED) 1.2.3 - Fitting rear levelling feet Note: 2 people may be required for this operation A set of adjustable back feet is provided with the kit. These parts are usually needed only in the case of a particularly uneven floor and when height adjustments in phase 1.2.1 proved unsuccessfull. • Temporarily remove the screws (A) holding the evaporator tray. A • Temporarily remove screw (B) • Pre-assemble the two nuts to bottom of the foot.
electrolux.com.au INSTALLATION (CONTINUED) 1.3 - Joining the Appliances Your appliances are delivered with hole covers that cover the screw holes. These holes are located on the top of the cabinet, opposite from the door hinge. Carfully remove these covers, care must be taken to avoid damaging the appliances. Remove covers Carefully pull the appliances together adjacent to the final installation location, then adjust the front and rear feet to the same height. Do not tighten 1.3.
INSTALLATION (CONTINUED) 1.4 - Bottom-front bracket installation 1.4.1 - Position the bottom-front bracket • Position the bottom-front bracket between the two cabinets. • Fasten with the two M4 screws using a phillips head screwdriver. • Extract the tensioner Extract the tensioner Extract the tensioner. 1.5 - Fit the centre cover • Push the centre cover between the two cabinets • Engage the bottom end of the centre cover into the tensioner of the bottom-front bracket.
electrolux.com.au ADJUSTING DOOR ALIGNMENT To complete installation of your joined appliances it may be necessary to slightly adjust door alignment on the individual appliance. This process is illustrated in the following section. 1. With the door open, remove the hinge cover by simultaneously pulling the cover away and up from the hinge. This action will release the clip that is retaining the cover to the hinge. Small plastic clip is located here.
NOTES
Electrolux Home Products Australia telephone: 1300 363 640 fax: 1800 350 067 email: customercare@electrolux.com.au web: electrolux.com.au Electrolux Home Products New Zealand telephone: 0800 436 245 fax: 0800 225 088 email: customercare@electrolux.co.nz web: electrolux.co.nz To add a touch of professional inspiration to your home, visit electrolux.com.au or electrolux.co.nz P/No. A04767001 © 2017 Electrolux Home Products Pty Ltd Print code: EMAN_FRICONN_Dec17 Issue date: Dec17 shop.electrolux.com.