User manual

The inlet hose
1. Connect the water inlet hose to the
back of the appliance.
2. Position it toward left or right
depending on the position of the water
tap.
20º20º
45º45º
Make sure that the inlet hose is
not in vertical position.
3. If necessary, loose the ring nut to set it
in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4" thread.
CAUTION! Make sure that
there are no leaks from the
couplings.
Do not use an extension hose if
the inlet hose is too short.
Contact the service centre for
the replacement of the inlet
hose.
Water-stop device
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing.
The red sector in the window «A» shows
this fault.
A
If this occurs, close the water tap and
contact the authorized service centre to
replace the hose.
Water drainage
The drain hose should be positioned at a
height of not less than 60 cm and not
more than 100 cm from the floor.
You can extend the drain hose
to maximum 400 cm. Contact
the authorized service centre
for the other drain hose and the
extension.
It is possible to connect the drain hose in
different ways:
1. Make a U shape with the drain hose
and put it around the plastic hose
guide.
8