S E R V I C E ENGLISH J O N S E R E D FRANÇAIS Please read these instructions carefully and make sure you understand them before using this unit. Manuel d’instructions Avant d’utiliser cet appareil, veuillez lire attentivement les instructions et assurez--vous de les avoir comprises. English Français Lesen Sie diese Hinweise zur Handhabung des Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie alle Anweisungen verstanden haben.
KEY TO SYMBOLS WARNING! This blower can be dangerous! Careless or improper use can cause serious or even fatal injury. Use unleaded or quality leaded petrol and two stroke oil. Read and understand the instruction manual before using the blower. Always wear eye and ear protection. WARNING! Be sure the bottom cover is secured or the vacuum tube is properly installed. Avoid the impeller blade with your hand or any foreign object.
WARNING! The blower can throw objects violently. --You can be blinded or injured. --Always wear eye protection. Thrown objects D HANDLE FUEL WITH CAUTION D D D D D D D D D Eliminate all sources of sparks or flame (including smoking, open flames, or work that can cause sparks) in the areas where fuel is mixed, poured, or stored. Mix and pour fuel in an outdoor area; store fuel in a cool, dry, well ventilated place; use an approved, marked container for all fuel purposes.
WHAT IS WHAT? WHAT IS WHAT? 1. Throttle Lock 2. Spark Plug 3. Nozzle 4. Blower Tube 5. Choke Lever 6. Throttle Trigger 7. ON/OFF Switch 8. 9. 10. 11. 12. 13. Rear Handle Starter Rope Elbow Tube Collection Bag Vacuum tubes Instruction manual 13 ASSEMBLY CARTON CONTENTS Check carton contents against the following list. S Blower S Blower tube S Nozzle S Upper vacuum tube S Lower vacuum tube S Elbow tube S Vacuum bag NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
Nozzle Blower Outlet Latch Area Vacuum Inlet Cover Latch Area Blower Tube Retention Posts VACUUM BAG ASSEMBLY 1. Open the zipper on the vacuum bag and insert the elbow tube. 2. Push the small end of the elbow tube through the small opening in the bag. Elbow Tube Small Opening 3. Gently tilt the handle of the screwdriver toward the back of the unit while pulling up on the vacuum inlet cover with your other hand. 4. Hold the vacuum inlet cover open until upper vacuum tube is installed. 5.
OPERATION OPERATING POSITION FUELING ENGINE WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded petrol. Before operation, petrol must be mixed with a good quality 2-cycle air-cooled engine oil. We recommend Jonsered® brand oil mixed at a ratio of 40:1 (2.5%). A 40:1 ratio is obtained by mixing 5 liters of unleaded petrol with 0,125 liter of oil. When mixing fuel, follow the instructions printed on the container.
2. Activate the throttle lock as follows: S Squeeze and hold throttle trigger S Press and hold throttle lock, then S Release the throttle trigger 3. Move choke lever to the FULL CHOKE position. STARTING A WARM ENGINE Throttle Lock Throttle Trigger If engine has not started after 6 pulls (at HALF CHOKE), repeat STARTING A COLD ENGINE procedure. If engine still does not start, proceed to STARTING A FLOODED ENGINE. 9. To stop the engine, move the ON/OFF switch to the OFF position. 1.
NOTE: Do not clean filter in gasoline or other flammable solvent. Doing so can create a fire hazard or produce harmful evaporative emissions. 3. Wash the filter in soap and water. 4. Allow filter to dry. 5. Apply a few drops of oil to the filter; squeeze filter to distribute oil. 6. Replace parts. REPLACE SPARK PLUG Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Ignition timing is fixed, nonadjustable. 1.
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE Engine will not start. Engine will not idle properly. CAUSE REMEDY 1.Engine flooded. 2.Fuel tank empty. 3.Spark plug not firing. 4.Fuel not reaching carburetor. 5.Compression low. 1.Fuel not reaching carburetor. 2.Carburetor requires adjustment. 3.Crankshaft seals worn. 4.Compression low. 1.Air filter dirty. 2.
This warranty shall be for a period of two years from the initial date of purchase. WHAT IS COVERED: REPAIR OR REPLACEMENT OF PARTS. Repair or replacement of any warranted part will be performed at no charge to the owner at an approved Jonsered servicing center. If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized service center or call Jonsered at 1--916--383--3511.
DECLARATION OF CONFORMITY relating to 2000/14/EC EU Declaration of Conformity relating to 2000/14/EC We, Poulan/Weed Eater, Division Electrolux North America, Inc., Texarkana, TX, 75501, USA, Tél. : +1 903 223 4100, declare under sole responsibility that the Jonsered model BV32 leaf blower from serial numbers 2002--148N00001 and onwards, conforms to the provisions of the DIRECTIVE. The nominal air flow is 0,096 m3/s. The measured sound power is 106,3 dB and the guaranteed sound power is 112 dB.
TECHNICAL DATA MODEL: BV32 ENGINE Engine displacement Maximum Engine Power, according to ISO 8893 Rotational Speeds Idle Speed +/-- 400 Maximum recommended output shaft speed Engine speed at maximum recommended output shaft speed MASS Unit without tube attachments, empty tank VOLUME Fuel tank SOUND PRESSURE LEVEL According to prEN 31806 Idling: Racing SOUND POWER LEVEL According to ISO/CD 10884 Idling: Racing VIBRATIONS According to ISO 7916 Idling: Racing: YEAR OF CONSTRUCTION: MANUFACTURER’S ADDRESS: 200