Instruction manual

-- 4 --
WHAT IS WHAT?
1. Throttle Lock 8. Rear Handle
2. Spark Plug 9. Starter Rope
3. Nozzle 10. Elbow Tube
4. Blower Tube 11. Collection Bag
5. Choke Lever 12. Vacuum tubes
6. Throttle Trigger 13. Instruction manual
7. ON/OFF Switch
WHAT IS WHAT?
13
ASSEMBLY
CARTON CONT ENT S
Check carton contents against the following
list.
S Blower
S Blower tube
S Nozzle
S Upper vacuum tube
S Lower vacuum tube
S Elbow tube
S Vacuum bag
NOTE: It is normal for the fuel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING: Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING: If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure. Fol-
low all safety information in the m anual and on
the unit.
D A standard screwdriver is required for as-
sembly.
BLOWER T UBE ASSEMBLY
1. Locate the two retention posts on the side
of the blower tube.
2. Align the retention grooves on the nozzle
with the retention posts on the blower tube
and push the nozzle onto the blower tube.
3. Turn the nozzle clockwise until the parts
snap in place and are firmly tightened.
4. Align retention grooves on the blower tube
with the retention posts in the blower outlet
and push the blower tube into the blower
outlet.
5. Turn the blower tube clockwise until the
parts snap in place and are firmly tightened.