Instruction manual

-- 5 --
Blower Tube
Nozzle
Retention
Posts
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Small
Opening
Zipper Opening
Elbow Tube
Groove
NOTE: Make sure edge of the small open-
ing is flush against the flared area of the el-
bow tube.
3. Close the zipper on the bag. Make sure the
zipper is closed completely .
4. Remove blower tube from engine.
Elbow Tube
5. Align grooves on the elbow tube with the
retention posts inside the blower outlet.
NOTE: For proper alignment, be sure elbow
tube is curved to the right as shown.
6. Insert the elbow tube into the blower outlet;
twist the elbow tube counterclockwise un-
til the parts snap together.
VACUUM TUBE ASSEMBLY
1. Align the lower vacuum tube as shown.
Push lower vacuum tube into upper vacu-
um tube.
Upper vacuum tube
L
ower
v
acuum tube
2. Insert a screwdriver into the latch area on
the vacuum inlet cover .
Latch Area
Blower
Outlet
Vacuum
Inlet Cover
Latch
Area
3. Gently tilt the handle of the screwdriver to-
ward the back of the unit while pulling up
on the vacuum inlet cover with your other
hand.
4. Hold the vacuum inlet cover open until up-
per vacuum tube is installed.
5. Align the grooves on the upper vacuum
tube with the retention posts inside the
vacuum inlet.
6. Insert the upper vacuum tube into the vac-
uum inlet; twist the upper vacuum tube
clockwise until parts snap together.
Vacuum Inlet Cover
Upper Vacuum Tube
Lower Vacuum Tube
7. When converting back to the blower fea-
ture, make sure latch on the vacuum inlet
cover is securely fastened.
SHOULDER STRAP A DJUSTMENT
(for vacuum use o nly)
1. Hold the unit as shown.
2. Pass the shoulder strap over your head
and onto your left shoulder. Snap the hook
onto the strap retainer in the top handle.
Retainer
3. Extend your right arm toward the rear of
the vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unit will not
operate properly.