Cooker Hood Instruction Manual

INSTALLING THE COOKER HOOD

Ducting Connection

Connect the ducting chosen to:

• the Ø150mm ducting spigot on top of the motor

housing, or the Ø150-120mm ducting spigot item 9

and secure using the jubilee clips item 25.

• A Ø120-125mm collar item 9.1 is provided to ﬁ t over

the Ø120mm ducting spigot when 125mm ducting is

ﬁ tted.

If the room where the cooker hood is to be used

contains a fuel burning appliance such as a central

heating boiler, then its ﬂ ue must be of the room

sealed or balanced ﬂ ue type.

If other types of ﬂ ue or appliances are ﬁ tted sure

that there is an adequate supply of air to the

room.

The cooker ducting (extraction mode) must never

be connected to central heating ﬂ ues, radiators or

water heaters etc.

Recirculation

The cooker hood is supplied speciﬁ ed for use in the

recirculation mode, with the charcoal ﬁ lter ﬁ tted.

In the recirculation mode contaminated air is passed

through the charcoal ﬁ lter to be puriﬁ ed and recirculated

into the kitchen through the grille outlets on either side

of the chimney.

Recirculation Connection

• Fix the connection item 15 to the frame using the 4

screws provided.

• Fix the ﬂ ange item 10 to the lower opening of the

connection item 15.

• Connect the hood air outlet to the ﬂ ange in the lower

part of the junction using a rigid or ﬂ exible ø 150

tube (by installer’s choice).

ø 150

ø 125

9.1