User manual

2. Let the vinegar dissolve the residual
limestone at the ambient temperature
for 30 minutes.
3. Clean the cavity with warm water and
a soft cloth.
11.3 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.4 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Set the function .
You cannot change the duration of the
Catalytic cleaning. You can delay the
start of the cleaning with the function:
END.
The signal sounds at the end of cleaning.
2. Press any button to stop the signal.
3. Turn off the oven.
To stop the cleaning before it finishes
turn the knob for the heating functions to
the off position.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
• if you press
and at the same
time.
11.6 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
ENGLISH 33