Operating Instructions Extractor Hood 56346 01.
electrolux Dear customer Please read through these operating instructions carefully. You should pay particular attention to the „Safety Instructions“ section. Please keep these operating instructions in a safe place for your reference, and pass them on to any subsequent owner of the appliance. These operating instructions include hints to help you correct any faults that may occur; see the section headed „Remedial measures in the event of a fault“.
electrolux 3 Contents Safety instructions ������������������������������������������������������������������������������������������������������������ 4 Electrical safety ���������������������������������������������������������������������������������������������������������� 4 Safety ������������������������������������������������������������������������������������������������������������������������ 4 Safety during use ���������������������������������������������������������������������������������
electrolux Safety instructions The safety of this appliance be used. complies with the generally • It is not permissible for safety recognised codes of practireasons to carry out any adapce and the applicable safety tations or modifications to the regulations. Despite that we extractor hood. consider it necessary to fami- • In the event of a fault, switch off liarise you with the following the appliance and pull the plug safety instructions. out of the mains socket.
electrolux 5 Safety during use Safety when cleaning Caution! Parts of the extractor hood may get hot during operation with cooking equipment. • Use the extractor hood for the ventilation of the hob area only. If the appliance is used incorrectly or for any purpose other than the one intended, the manufacturer can accept no liability for any damage or loss. • It is forbidden to flambé below the hood, whether switched off or on (risk of fire).
electrolux Disposal Packaging materials The packaging materials are eco-friendly and recyclable. The plastic components are labelled, e.g. ‚PE‘, ‚PS‘, etc. Dispose of the packaging materials according to their labelling in the containers provided for that purpose at local authority waste disposal sites.
electrolux 7 Appliance description Extractor hood equipment 1 2 3 4 1 Extending hood Light Metal filter Appliance nameplate Special accessories 5 Safety grille DA-SG Set of regeneratable long-life filter, AKF LL45-14, comprised of: 2 3 2 4 6 Activated carbon filter, AKF LL45-14 7 Reminder sticker no. 56331 6 5 7 For special installations in open-plan kitchens the backflow flap can be removed with a tool and the safety grille ( 5 ) can be inserted.
electrolux Before using for the first time Special accessories Regeneratable activated carbon filter: The activated carbon filter must be regenerated before using the appliance for the first time, as every activated carbon filter absorbs moisture. The moisture must be extracted. Regeneration of the activated carbon filter: Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up for an hour at 230 °C. Then allow the filter to cool down completely for two hours.
electrolux 9 Cleaning and Maintenance Beware! Do not use any abrasive cleaners, brushes, sponges or scouring powder. External cleaning The external components are to be cleaned with a microfibre cloth. When cleaning the exterior, ensure that the cloth is worked in line with the texture of the stainless steel surface finish (the fine horizontal lines).
electrolux Reinserting the metal filters 3. Lift up the metal filters at the rear and slot them in place at the front. 3 Cleaning the filter space Clean the filter space with a dry piece of kitchen roll each time the metal filters are cleaned or replaced. The fan is running! Caution! Do not damage or remove the appliance nameplate. Regenerating the activated carbon filter Handling of the activated carbon filter according to operating instructions.
electrolux 11 Regeneration Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it must be regenerated after 2 months at the latest. 3. Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up for an hour at 230 °C. 4. Then allow the filter to cool down completely for two hours. The filter can then be placed in the extractor hood again. Your appliance is now ready for another 2 months use. The filter loses its effectiveness after approx.
electrolux Replacing the LED bulbs The extractor hood must be disconnected from the mains supply. (Pull out the plug or switch off the circuit breaker.) When replacing the lamp, use the same 3W GU10 model again. Please note that LED energy saving lamps 220-240V, GU10 with 3-5W (IP23) can be used with this appliance. Please bear in mind that LED bulbs have to be specially disposed of. You can hand these back at any appropriate sales outlet.
electrolux 13 Remedial action in the event of faults Check whether you can correct any minor faults on the appliance yourself, by means of the following instructions. If this information is of no help in your specific case, please contact After Sales. Fault Cause Solution • The extractor hood will not work at all. • The fan motor will not run. • No mains power supply. • Check whether the fuse/ circuit breaker is OK. • Check whether the mains cable is correctly plugged in.
electrolux Installation Instructions Safety instructions The risk-free operation of appliances (e.g chimney, gas cooker) and extractor hoods jointly connected to a single flue is only guaranteed if the room and/ or apartment are ventilated from outside by means of a suitable air inlet aperture of approx. 500-600 sq cm, and hence negative pressure is avoided when the extractor hood is in operation. The negative pressure in the room must not be greater than 4 Pa.
electrolux 15 Installation with herbs and spices cupboard, height 635 mm (5/6), new, and installation with herbs and spices cupboard, height 508 mm (4/6) with door 635 mm (5/6), replacement market. max. 140 Use the templates and follow the instructions on them. 127 5/6= 635 4/6= 508 max. 140 Caution! If no back draught flap is installed it is absolutely necessary to have an air vent of at least 200 cm2! One option is to use the protective grid accessory.
electrolux Electrical connections / power lead Caution! The electrical connections must be carried out by an approved installer. mains socket Beware! The plug must be accessible after installation. A type 12 or type 13 mains socket is to be provided. The connecting cable is approx. 1m in length. When replacing the connecting cable, the cable type must be at least H05RR-F (spare part no. 375 0432-00/1).
electrolux 17 Energy efficiency Product Fiche according to (EU) No 65/2014 Annual Energy Consumption - AEChood ELECTROLUX DAGL5530 DAGL6030 82,2 Energy Efficiency Class C Fluid Dynamic Efficiency - FDEhood 18,4 Fluid Dynamic Efficiency class C Light Efficiency - LEhood 59 lux/W Lighting Efficiency Class A lux Grease Filtering Efficiency - GFEhood 99,0 % Grease Filtering Efficiency class A Minimum Air Flow in normal use 200 m3/h Maximum Air Flow in normal use 619 m3/h Air Flow at intensi
electrolux Service The well-established Electrolux After Sales service is available to all our customers. Before you call for After Sales Make sure that the problem is not one of an operating error. Check your extractor hood as set out in the section „Remedial action in the event of faults “. The nameplate is located behind the right-hand filter and on the warranty document. When you call on the services of After Sales • Make a precise note of your observations.
electrolux 19 After Sales Service Centres 5506 Mägenwil/Zürich Industriestr. 10 9014 St. Gallen Zürcherstrasse 204 e 4052 Basel Birsstrasse 320 b St. Jakob-Turm 6020 Emmenbrücke Seetalstrasse 11 7000 Chur Comercialstrasse 19 3018 Bern Morgenstrasse 131 1028 Préverenges Le Trési 6 6928 Manno Via Violino 11 You can order spare parts, accessories and care products online at: www.electrolux.ch Technical advice / Sales 8048 Zürich Badenerstrasse 587 Tel.