Operating Instructions Extractor Hood 56326 01.
electrolux Dear customer Please read through these operating instructions carefully. You should pay particular attention to the „Safety Instructions“ section. Please keep these operating instructions in a safe place for your reference, and pass them on to any subsequent owner of the appliance. These operating instructions include hints to help you correct any faults that may occur; see the section headed „Remedial measures in the event of a fault“.
electrolux 3 Contents Safety instructions ������������������������������������������������������������������������������������������������������������ 4 Electrical safety ���������������������������������������������������������������������������������������������������������� 4 Safety ������������������������������������������������������������������������������������������������������������������������ 4 Safety during use ���������������������������������������������������������������������������������
electrolux Safety instructions physical, sensory or mental, capabilities, or lacking experience and/or lacking knowledge, unless they are supervised by a person responsible for their safety, or have been instructed by him/her in how the appliance is to be used. The safety of this appliance complies with the generally recognised codes of practice and the applicable safety regulations. Despite that we consider it necessary to familiarise you with the following safety instructions.
electrolux 5 Disposal Packaging materials The packaging materials are eco-friendly and recyclable. The plastic components are labelled, e.g. ‚PE‘, ‚PS‘, etc. Dispose of the packaging materials according to their labelling in the containers provided for that purpose at local authority waste disposal sites.
electrolux Appliance description Extractor hood equipment 1 2 3 4 5 1 Extending hood Control panel Light Metal filter Appliance nameplate 2 Special accessories 6 Regeneratable long-life filter AKF LL45-14 7 Safety grille DA-SG 3 4 3 5 6 For special installations in open-plan kitchens the backflow flap can be removed with a tool and the safety grille ( 7 ) can be inserted.
electrolux 7 Grease and activated carbon filter monitor function The extractor hood has a monitor function for the grease filters and the activated carbon filter. • After 40 hours of operation, indicator light f reminds the user that the grease filters are due for cleaning. • If an activated carbon filter is fitted for recirculating mode, indicator light C re- minds the user when switching off after 120 hours of operation that the activated carbon filter must be regenerated or replaced.
electrolux Extractor hood controls Always switch the extractor hood on before starting cooking. Switching the appliance on / off Switching on / off by means of the extending hood • Pull out the extending hood. • Press the button for the required speed. When a speed button is pressed the fan is switched on and the associated LED lights up. The fan speed is switched off by pressing the button again. Pull out the extending hood. The most recently use speed is automatically switched on.
electrolux 9 The intensive speed runs for five minutes, then the fan is automatically reset to the most recently selected speed (speeds 1-3), provided that a speed has been preselected. To switch off the intensive speed prematurely: • Press the intensive speed button again while the fan is running. Intensive speed The fan is automatically reset to the most recently selected speed (speeds 1-3), provided that a speed has been selected.
electrolux The monitoring functions can only be set when the ventilation is switched off and the glass extension cover is not pulled out. Grease filter monitor function The monitor function for the grease filter is enabled by default. After 40 hours of operation, indicator light f is continuously illuminated when the hood is extended. It is time to clean the filter when indicator light f comes on, if not sooner.
electrolux 11 Cleaning and Maintenance Beware! Do not use any abrasive cleaners, brushes, sponges or scouring powder. Caution! The pull-out should not be removed! component External cleaning The external components are to be cleaned with a microfibre cloth. When cleaning the exterior, ensure that the cloth is worked in line with the texture of the stainless steel surface finish (the fine horizontal lines).
electrolux Reinserting the metal filters 3. Lift up the metal filters at the rear and slot them in place at the front. 3 Cleaning the filter space Clean the filter space with a dry piece of kitchen roll each time the metal filters are cleaned or replaced. The fan is running! Caution: Do not damage or remove the appliance nameplate. Regenerating the activated carbon filter Handling of the activated carbon filter according to operating instructions.
electrolux 13 Regeneration Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it must be regenerated after 2 months at the latest. 3. Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up for an hour at 230 °C. 4. Then allow the filter to cool down completely for two hours. The filter can then be placed in the extractor hood again. Your appliance is now ready for another 2 months use. The filter loses its effectiveness after approx.
electrolux Replacing the halogen bulbs The extractor hood must be disconnected from the mains supply. (Pull out the plug or switch off the circuit breaker.) Caution! All the bulbs become hot; be careful when replacing them. Caution! Do not use dimmable LED‘s ! Please note that energy-saving halogen bulbs rated at 230 volts up to a maximum of 25 watts can be used for this appliance, or especially low-energy bulbs with a GU10 fitting, rated at 250 volts and 3 to 7 watts (e.g. IP64-rated LEDs).
electrolux 15 Fault Cause Solution • The extractor hood will not work at all. • The fan motor will not run. • No mains power supply. • Check whether the fuse/ circuit breaker is OK. • Check whether the mains cable is correctly plugged in. • Extending hood not pulled out. • Pull out the extending hood. • No light • Bulb blown. • Replace bulb. • The appliance does not „extract“ well. • Very airtight doors and windows, resulting in negative pressure.
electrolux Installation Instructions Safety instructions The risk-free operation of appliances (e.g chimney, gas cooker) and extractor hoods jointly connected to a single flue is only guaranteed if the room and/ or apartment are ventilated from outside by means of a suitable air inlet aperture of approx. 500-600 sq cm, and hence negative pressure is avoided when the extractor hood is in operation. The negative pressure in the room must not be greater than 4 Pa.
electrolux 17 Installation with herbs and spices cupboard, height 635 mm (5/6), new, and installation with herbs and spices cupboard, height 508 mm (4/6) with door 635 mm (5/6), replacement market. max. 140 Use the templates and follow the instructions on them. 127 5/6= 635 4/6= 508 max. 140 Caution! If no back draught flap is installed it is absolutely necessary to have an air vent of at least 200 cm2! One option is to use the protective grid accessory.
electrolux Electrical connections / power lead Caution! The electrical connections must be carried out by an approved installer. mains socket Beware! The plug must be accessible after installation. A type 12 or type 13 mains socket is to be provided. The connecting cable is approx. 1m in length. When replacing the connecting cable, the cable type must be at least H05RR-F (spare part no. 375 0432-00/1).
electrolux 19 Service The well-established Electrolux After Sales service is available to all our customers. Before you call for After Sales Make sure that the problem is not one of an operating error. Check your extractor hood as set out in the section „Remedial action in the event of faults “. The nameplate is located behind the right-hand filter and on the warranty document. When you call on the services of After Sales • Make a precise note of your observations.
electrolux After Sales Service Centres 5506 Mägenwil/Zürich Industriestr. 10 9014 St. Gallen Zürcherstrasse 204 e 4052 Basel Birsstrasse 320 b St. Jakob-Turm 6020 Emmenbrücke Seetalstrasse 11 7000 Chur Comercialstrasse 19 3018 Bern Morgenstrasse 131 Préverenges Le Trési 6 6916 Grancia Zona Industriale E You can order spare parts, accessories and care products online at: www.electrolux.ch Technical advice / Sales 8048 Zürich Badenerstrasse 587 Tel.