User manual

RATING PLATE
Record the model, product and serial numbers on the
back cover from the rating plate. This is situated on the
lower front frame of the cooker and can be seen upon
opening the fan oven door.
The cooker must be protected by a suitably rated fuse
or circuit breaker. The rating of the cooker is given on
the rating plate.
Do not remove the rating plate from the cooker as
this may invalidate the guarantee.
INSTALLATION
If your cooker has been damaged in transit, contact
your supplier immediately. DO NOT attempt to install it.
Your cooker left the factory fully packaged to protect it
from damage. If it is delivered without packaging and
damage has occurred the manufacturer cannot accept
responsibility. Contact your supplier for advice.
Once the packaging has been removed the cooker
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the cooker as damage
may occur.
Connection to the electricity supply must be carried out
by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at least
3mm contact separation. The cable must have
conductors of sufficiently high cross-sectional area to
prevent overheating and deterioration.
The recommended cross-section area is six square
millimetres (6.00mm²).
The cable should be routed away from potentially hot
areas marked by X in the diagram below.
To move the cooker, open the fan oven door, and lift
the cooker by holding inside the top of the
compartment.
This is a type Y cooker which means it is free-standing
and can be fitted with cabinets on one or both sides. It
may also be fitted in a corner setting.
Ensure that the cooker is standing level.
Side walls which are above hob level should be
protected by heat resistant non-combustible material
and MUST NOT be nearer than 40mm to the hob side.
A nominal air gap of 2mm all around the cooker is
required to enable the cooker to be moved into position.
A spacer has been incorporated into the back of the
appliance to ensure an air gap of 10mm is maintained
at hotplate level. Tiles or other forms of deep wall
covering should not obscure this gap.
7
INTRODUCTION
WARNING: THIS COOKER MUST BE EARTHED
REAR VIEW