User manual

5www.electrolux.com
CNS
KR
ID
TH
VN
EN
Denim Cotton or Linen Use maximum steam. Apply maximum steam by
pressing and holding the steam on/off button.
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the
recommendations in the table!
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Soleplate is not heating even
though iron is turned on.
Connection problem Select higher programme like
“Cotton”.
Temperature control is in
“Delicate” position.
Select higher programme like
“Cotton”.
Iron does not produce steam. Not enough water in tank. Fill water tank (see “Getting
started”, no 2).
Selected temperature is lower
than that specified to use with
steam.
Increase temperature to at least
“Cotton”.
Steam jet and vertical steam jet
function does not work.
Steam jet function was used very
frequently within a short period.
Put iron on horizontal position
and wait before using steam jet
function.
Iron is not hot enough. Select the Cotton setting
(“Cotton” to “Linen”) suitable for
steam ironing. Put the iron on its
heel and wait until temperature
indicator light turns off.
Water leaks from the soleplate
during ironing.
Iron is not hot enough. Select the Cotton setting
(“Cotton” to “Linen”) suitable for
steam ironing. Put the iron on its
heel and wait until temperature
indicator light turns off.
Water leaks from the soleplate
while the iron is cooling down or
after it has been stored.
You may have forgot to put
steam lever in “no steam
position”.
Turn steam lever to “no steam
position” position when finished
ironing (see “After use”, no 12).
Flakes and impurities come out
of the soleplate during ironing.
You may have used hard water,
which has caused scale flakes to
develop in the water tank.
Clean the iron according
to Cleaning section (see
“Maintenence”, no 16).
Brown streaks come out of the
soleplate while ironing and stain
the linen.
You may have used non
recommended chemical
descaling agents.
Clean the iron according
to Cleaning section (see
“Maintenence”, no 16).
Fabric fibers have accumulated
in the holes of the soleplate and
are burning.
Clean the soleplate with a damp
soft cloth.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed
before ironing.
Please rinse the fabrics properly
before ironing.