User Guide

8 www.electrolux.com
CNT
CNS
KR
ID
TH
VN
EN
FABRIC
TEMPERATURE SET
TING
IRONING RECOMMENDATION
Denim Cotton or Linen Use maximum steam. Apply maximum steam by
pressing and holding the steam on/off button.
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the
recommendations in the table!
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Soleplate is not heating
even though iron is turned
on.
Connection problem Check main power supply cable, plug
and outlet.
Temperature control is in
“Outdoor” position.
Select higher programme like “
Cotton”.
Iron does not produce
steam.
Not enough water in tank. Fill water tank (see “Getting started”,
no 2).
Selected temperature is lower
than that specified to use with
steam.
Increase temperature to at least “
Cotton”.
Steam jet and vertical
steam jet function does not
work.
Steam jet function was used very
frequently within a short period.
Put iron on horizontal position and
wait before using steam jet function.
Iron is not hot enough. Adjust the proper temperature to
steam ironing (up to “
Cotton”). Put
iron in vertical position and wait until
temperature indicator light turns off.
Water leaks from the
soleplate during ironing.
The iron is not hot enough. Select the Cotton setting (“
Cotton”
to maximum) suitable for steam
ironing. Put the iron on its heel and
wait until the headlight is on before
you start ironing.
Flakes and impurities come
out of the soleplate during
ironing.
You have used hard water,
which has caused scale flakes to
develop in the water tank. Clean
the iron according to Cleaning
section.
Press and hold the steam button for
about one minute to get steam. Then
hold one more minute in order to clean
the steam generating system. Before
starting ironing, please test your iron
on an old towel to ensure that no
residues inside the iron are transferred
to your garments.
Water leaks from the
soleplate while the iron is
cooling down or after it has
been stored.
The iron has been put in
horizontal position while there is
still water in the water tank.
Empty the water tank.
Brown streaks come out of
the soleplate while ironing
and stain the linen.
You may have used chemical
descaling agents different from
the recommendation.
To prevent this from happening, it is
recommended to exchange the Soft
Water Activator according to the
indications.
Fabric fibers have accumulated
in the holes of the soleplate and
are burning.
Clean the soleplate with a damp soft
cloth.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed
before ironing.
Please rinse the fabrics properly
before ironing.