User manual

17ENGLISH
IMPORTANT: always clean the cap-
puccino system immediately after use.
Proceed as follows:
• Pressthe icon (B12) and then
press the OK icon (B9) to discharge a
small amount of steam for a few sec-
onds. This empties the steam spout of
all traces of milk.
IMPORTANT: to ensure the hygiene of
the appliance, you are recommended
to carry out this procedure each time
you make cappuccino to avoid stale
milk remaining in the circuit.
• Waitforthecappuccinomakertocool
down, then holding the cappuccino
maker lever firmly in one hand, un-
screw the cappuccino maker itself with
the other, turning it anticlockwise and
removing it downwards.
• Removethecappuccinomakernozzle
by pulling it downwards.
•Washthecappuccinomakerandnoz-
zle thoroughly in hot water.
•Makesurethetwoholesshowninfig-
ure 25 are not blocked. If necessary,
clean with a pin.
•Replacethenozzlebyinsertingit
upwards into the cappuccino maker.
•Replacethecappuccinomakerby
pushing it upwards and rotating it anti-
clockwise.
•Usingthisfunctionyoucanautomati-
cally make a number of cups of coffee
(4, 6) directly in a jug to keep the cof-
fee hot.
Please choose a jug with the right
capacity.
•Placeitunderthecoffeespout.The
coffee spout (A13) must be fully raised
to enable the jug to be inserted.
•Pressthe icon (B14). “FILL BEAN
CONT. AND WATER TANK, EMPTY
WASTE CONT., PRESS OK” is dis-
played. Make sure the water tank is
full, the bean container is full enough
and the waste coffee container is com-
pletely empty.
•PresstheOKicon(B9).
•Presstheicon (B2) to change the
type of coffee, the taste, and the num-
ber of cups.
•Confirmbypressingthe icon (B14).
The display shows a progress bar
which indicates coffee making process.
When the progress bar is complete,
the appliance finishes the process.
IMPORTANT!
When the coffee beans are insuf-
ficient to complete the required
function, the appliance stops the
process and waits for the bean
container to be filled again and the
icon (B14) to be pressed. For
example, when you want to make
4 cups of coffee but the beans
are insufficient, the appliance
makes 2 cups then stops making
coffee. Fill the bean container and
press the icon (B14). Once
the container has been filled, the
appliance makes the 2 remaining
cups only to reach the required
number of 4 cups.
If there is not enough water in
the tank to complete the required
function or the waste coffee
container is full, the appliance
interrupts the process.
After rectifying the problem, the
programme must be started again.
In this case, you must take the
amount of coffee already deliv-
ered into account to avoid the jug
overflowing.
14. MAKING A CERTAIN NUMBER OF CUPS OF COFFEE
WITH THE JUG FUNCTION