User manual

11.4 Removing / inserting the
door
Remove the door to clean the inner side
of the appliance.
WARNING!
Pull the door away from the appli-
ance. The door is heavy!
CAUTION!
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
3
4
2
Removing the door
1.
Open the door as far as it goes.
2.
Lift up the clamping levers on both
door hinges fully.
3.
Hold the door on both sides with both
hands and close it approximately 3 /
4 of the way going through the point
of resistance.
3
4
4
60º
5
Inserting the door
1.
Hold the door on both sides at an an-
gle of approximately 60° (from the
side of the door with the handle).
2.
Push the door hinges at the same
time into the two recesses at the bot-
tom of the appliance on the left and
the right as far as they go.
3.
Shut the door only to a point of resist-
ance and then open it as far as it
goes.
4.
Lock the clamping levers on the hing-
es fully.
5.
Close the door.
11.5 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp on the left side of
the cavity:
1.
Remove the left shelf support.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
20
www.electrolux.com